Nissan Skyline R34 workshop service manual page 118

text version of content this owner's manual page from owners manual to the vehicle Nissan Skyline, year of production 1998 - 2002:

TCS/ABS SYSTEM CONSULT for Throttle Control Unit Control System (Cont'd) DATA MONITOR MODE -- - I Select monitor item Display All signals Selection Remarks I from menu I I THRTL POS SEN [~l l o I n Dispiays throttle position sensor signal voltage. EG THRTL OPENING lo] 1 0 I Displays throttle angle computed based on throttle position sensor signal voltage. THRTL POS SE2 MI 0 1; Displays throttle motor sensor signal voltage. AT THRL2 OPENING rOl / 0 Displays throttle motor angle computed based on throttle BATTERY VOLT MI 0 I A motor sensor signal voltage. Displays the battery voltage for the control unit. TH OPEN SIG ims]/ 0 I A Displays the pulse width of the throttle motor target angle signal from the TCSIABS control unit. CLOSED THUSW [ONIOFF] 0 A lndicates the switch status (ONIOFF) based on the throttle position sensor signal. NEUT POSl SW [ONIOFF] 0 A lndicates the switch status (ONIOFF) based on the parW neutral position switch signal. START SIGNAL [ONIOFF] 0 A lndicates the status (ONIOFF) based on the starter signal. TH OPEN CONT ["I 0 A Displays the throttle motor control target computed by the TH MOTOR DUTY I"/.] I 0 I A control unit based on each input signal. lndicates the throttle motor drive duty. lndicates the throttle motor relay status (ON/OFF). TCS SIGNAL [ONIOFF] / lndicates ON when the throttle motor angle reaches a specified iower limit. OIa lndicates "VALID" when throttle motor target angle signal is TCS FLAG received from the TCS/ABS control unit and the throttle control unit closes the throttle motor. lndicates the condition of the communication between TCS/ COMM COND [ONIOFFJ 0 A ABS control unit and throttle control unit. Normally ON is indicated, and OFF is shown when there is failure. lndicates if the throttle motor has been fully closed before. TH CLSD LRN PoNwEqI 0 / A "DONE" is indicated when it has, and "YET" is shown when VOLTAGE PI I I A it has not yet. lndicates the voltage measured with a voltage probe. lndicates the pulse measured with a pulse probe. PULSE [ms, Hz, %I - h If it cannot be measured, "%" is shown on the display. The %" mark is also shown to the left of the final data until the measuring result is output. I ACTIVE TEST PROCEDURE 1. Turn ignition switch OFF. 2. Connect CONSULT connector to data link connector for CON- S U LT. 3. Turn ignition switch ON. 4. Touch "START" on CONSULT screen. 5. Touch "THROTTLE CONTROL" on CONSULT screen.

owners manual Nissan Skyline

owners manual Nissan Skyline - year of production: 1998, 1999, 2000, 2001, 2002 - Nissan Skyline R34 workshop service manual EN