Nissan Skyline R34 workshop service manual page 115

text version of content this owner's manual page from owners manual to the vehicle Nissan Skyline, year of production 1998 - 2002:

TCS/ABS SYSTEM Self-diagnosis for TCSfABS Control Unit Control System (Cont'd) MALFUNCTION CODE/SYMPTOM CHART I I Detection time I Malfunc- Lamp ON a Fail-safe tion code Check item Engine In driving ABS TCS OFF SLlP operation No. running 12 Normal - - - - - - 21 Front right wheel sensor (open-circuit) 0 0 0 0 0 0 22 Front right wheel sensor (short-circuit) - 0 0 0 0 0 25 Front left wheel sensor (open-circuit) 0 0 0 0 0 0 26 Front left wheel sensor (short-circuit) - 0 0 0 0 0 31 Rear right wheel sensor (open-circuit) 0 0 0 0 0 0 32 Rear right wheel sensor (short-circuit) - 0 0 0 0 0 35 Rear left wheel sensor (open-circuit) 0 0 0 0 0 0 36 Rear left wheel sensor (short-circuit) - 0 0 0 0 0 41 Front right outlet solenoid valve and circuit 0 0 0 0 0 0 42 Front right inlet solenoid valve and circuit 0 0 0 0 0 0 45 Front left outlet solenoid valve and circuit 0 0 0 0 0 0 46 Front left inlet solenoid valve and circuit 0 0 0 0 0 0 55 Rear outlet solenoid valve and circuit 0 0 0 0 0 0 56 Rear right inlet solenoid valve and circuit 0 0 0 0 0 0 57 Battery voltage (low) 0 0 0 0 0 -'I Throttle control unit system or circuit for the corn- 58 munication line between TCSIABS control unit and 0 0 -*2 0 0 0 throttle control unit 61 Actuator motor and motor relay circuit 0 0 0 0 0 0 63 Actuator relay circuit 0 0 0 0 0 0 71 TCSIABS control unit 0 0 05 0 0'5 0 75 Total control signal (multiple signal) for engine, IVT 0 0 - 0 0 0 and TCS/ABS 80 Engine speed signal - - - 0'3 0 0 0 83 Monitoring of total control signal (multiple signal) for 0 0 - 0 0 0 engine, AfT and TCS/ABS - 84 Engine system component fuel condition 0 0 0 0 0 85 Incomplete start process of total control signal (mul- 0 0 - 0 0 0 tiple signal) for engine, AfT and TCSIABS 86 Continuous start process of total control signal 0 0 - 0 0 0 (multiple signal) for engine, and TCS/ABS - - - NO indi- Remains OFF: Data link connector circuit 0 0 -'4 cation Remains ON: SLIP indicator lamp circuit shorted, (no blink- TCSIABS control unit or self-diagnostic check termi- 0 0 0 0 0 -'4 ing) nal circuit open NOTE: malfunction code No. 58 is indicated, perform the When the code Nos. throttle control unit self-diagnosis. When the malfunction 75, 80, 83, 84, 85 or 86 is indicated, perform the self-diaqnosis for ECM-TCM or ECM. 'I: Fail-safe operation is not activated. A signal from control unit suspends TCS and ABS control operation. Brakes operate conventionally and the vehicle operates in the same manner as a vehicle without the TCS. After specified battery voltage resumes, the TCS OFF indicator lamp and the ABS warning lamp go off, allowing for TCS and ABS control operation. '2: TCS operation only stops and fail-safe operation is activated, allowing for ABS control operation. '3: Malfunction is detected only when TCS is in operation. '4: When there are malfunctions in the self-diagnostic check terminal circuit (terminal 4 of the data link connector for CONSULT) and SLlP indicator lamp circuit, fail-safe operation is not activated. '5: Some malfunctions in the TCS/ABS control unit cause the SLlP indicator lamp and the ABS warning lamp to go off sepa- rately.

owners manual Nissan Skyline

owners manual Nissan Skyline - year of production: 1998, 1999, 2000, 2001, 2002 - Nissan Skyline R34 workshop service manual EN