owners manual Subaru Outback

all ratings: 0 average rating: 5

Starting and operating/Starting and stopping the engine (models without push–button ignition switch)7-11 “LOCK” position and wait for at least“N” position and that the parking brake is! Whenthesteering lock cannot be 10 seconds. After checking that theapplied. released parking brake is applied, turn the & Stopping the engine Whenyoucannotrestarttheenginedueto ignition switch to the “START” position the steering lock, perform the following while depressing the accelerator pedal WARNING steps. slightly (approximately a quarter of the full stroke). Release the acceleratorDo not stop the engine when the!MTmodels pedal as soon as the engine starts.vehicle is moving. This will cause1. Check that the parking brake is ap- (2) If this fails to start the engine, turnloss of power to the power steeringplied. the ignition switch back to the “LOCK”andthebrakebooster,makingsteer-2. Turn off unnecessary lights and ac- position and wait for at least 10ing and braking more difficult. Itcessories. seconds. Then fully depress the accel-could also result in accidental acti-3. Depress the clutch pedal to the floor erator pedal and turn the ignitionvationofthe“LOCK”positionontheand shift the shift lever into neutral. Hold switch to the “START” position. If theignition switch, causing the steeringthe clutch pedal to the floor while starting engine starts, quickly release thewheel to lock. the engine. accelerator pedal. (3) If this fails to start the engine, turnThe ignition switch should be turned off4. Turn the ignition switch to the “ON” the ignition switch again to the “LOCK”only when the vehicle is stopped and theposition while turning the steering wheel position. After waiting for 10 secondsengine is idling. left and right. or longer, turn the ignition switch to the 5. Check the operation of the warning “START” position without depressing&Steering lock (models with-and indicator lights. the accelerator pedal. out “keyless access with 6. Turn the ignition switch to the “START” (4) If the engine still refuses to start,push-button start system”)position without depressing the accelera- contact your nearest SUBARU dealer tor pedal. for assistance. After stopping the engine and the key is7. Release the key immediately after the 6. Confirm that all warning and indicatorremoved from ignition switch, the steeringengine has started. lights have turned off after the engine haswheel will be locked due to the steering started. The fuel injection system auto-lock function. If you cannot start the engine, there may matically lowers the idle speed as theWhentheengineis restarted, the steeringbe a malfunction in the steering lock engine warms up. lock will be automatically canceled.function. Immediately contact your nearest SUBARUdealer. While the engine is warming up, make sure that the select lever is at the “P” or – CONTINUED –

All pages in one PDF file!

How to get the code?
It's very simple! Just pay through a secure PayPal payment.
It will take no longer than a few minutes.
You will receive the code immediately after payment.
The code will be displayed on the screen and will be sent to you by e-mail address.

---

:

How many PDF files you want to download:
1 PDF file $4,00 USD 3 PDF files $8,00 USD 5 PDF files $12,00 USD

- I agree to the terms of service

Site map |
Privacy |
DMCA |
Terms of service
contact e-mail: contact @ man4car.com
All marks are the property of their respective holders