owners manual Subaru Outback

all ratings: 0 average rating: 5

Starting and operating/Remote engine start system (dealer option)7-21 event that a transmitter is lost, stolen,eight transmitters) Becarefulnottoallowchildrento damaged or additional transmitters are8. The system will exit the transmittertouch the battery and any re- desired (the system will accept up to eightlearn mode if the key is turned to themoved parts; children could transmitters). New remote engine start“LOCK” position, the door is closed orswallow them. transmitters can be programmed accord-after 2 minutes. . There is a danger of explosion if ing to the following procedure. an incorrect replacement battery 1. Open the driver’s door (the driver’s&Systemmaintenance is used. Replace only with the door must remain opened throughout theNOTE same or equivalent type of bat- entire process). For models without “keyless accesstery. 2. Depress and hold the brake pedal.with push-button start system”:. Batteries should not be exposed 3. Turn the ignition switch to “ON” thenIn the event that the vehicle’s battery isto excessive heat such as sun- “LOCK”, back to “ON” then “LOCK”, backreplaced, discharged or disconnected,shine, fire or the like. to “ON” then “LOCK”, then back to “ON”it will be necessary to start the vehicle again and leave the ignition “ON” through-a minimum of one time using the keyFor models with “keyless access with out the programming process. prior to activating the remote enginepush-button start system: 4. The system will flash the side markerstart system. This is required to allowPerform the procedure described in “Re- lights, tail lights and parking lights andthe vehicle electronic systems to re-placing battery of access key” F11-49. honk the horn three times, indicating thatsynchronize. For models without “keyless access the system has entered the transmitter with push-button start system”: learn mode. ! Changing the batteries 5. Press and release the “ ” button on The 3-volt lithium battery (model CR- the transmitter that you want to program.CAUTION 2032) supplied in your remote engine start transmitter should last approximately one 6. The system will flash the side marker. Donotletdust,oilorwatergetonyear, depending on usage. When the lights, tail lights and parking lights andor in the remote engine startbattery begins to weaken, you will notice honk the horn one time, indicating that thetransmitter when replacing thea decrease in range (distance from the system has learned the transmitter. Uponbattery. vehicle that your remote control operates). successful programming, the remote start Follow the instructions below to change confirmation transmitter button will flash. Be careful not to damage thethe remote engine start transmitter battery. one time. printed circuit board in the re- 7. Repeat step 5 for any additionalmote engine start transmitter transmitters (the system will accept up towhen replacing the battery. – CONTINUED –

All pages in one PDF file!

How to get the code?
It's very simple! Just pay through a secure PayPal payment.
It will take no longer than a few minutes.
You will receive the code immediately after payment.
The code will be displayed on the screen and will be sent to you by e-mail address.

---

:

How many PDF files you want to download:
1 PDF file $4,00 USD 3 PDF files $8,00 USD 5 PDF files $12,00 USD

- I agree to the terms of service

Site map |
Privacy |
DMCA |
Terms of service
contact e-mail: contact @ man4car.com
All marks are the property of their respective holders