owners manual Seat Ateca

all ratings: 0 average rating: 5

Operation Information on the brakesAt high speed and with the windscreen wip-more pressure on the brake pedal and allow ers activated, the brake pads will brieflyfor longer stopping distances. New brake pads touch the brake discs. This takes place, al- though unnoticeable to the driver, at regularLow brake fluid level For the first 400 km (250 miles), new brake intervals to improve the response time of the pads have not yet reached their maximum Malfunctions can occur in the brake system if brakes when they are wet. braking capacity, and need to be “run in” the brake fluid level is too low. The brake flu- first. However, you can compensate for the id level is monitored electronically. The effectiveness of the brakes can also be slightly reduced braking effect by applying temporarily reduced if the vehicle is driven more pressure on the brake pedal. Avoid for some distance without using the brakesBrake servo overloading the brakes while running them when there is a lot of salt on the road in win- The brake servo increases the pressure you in. ter. The layer of salt that accumulates on the apply to the brake pedal. It works only when discs and pads can be removed by gently ap- the engine is running. Wear plying the brakes a few times. The rate of wear on the brake pads depends WARNING Corrosion a great deal on how you drive and the condi- ● Apply the brakes heavily to clean the brake tions in which the vehicle is operated. This is There may be a tendency for corrosion to system only in a suitable traffic situation. Do a particular problem in urban traffic and form on the discs and dirt to build up on the not put other road users in danger: there is short stretches, or with very sporty driving. brake pads if the vehicle is used infrequentlyrisk of causing an accident. or the brakes are not used very often. Depending on the speed, the braking force ● Ensure the vehicle does not move while in and the environmental conditions (for exam- neutral, when the engine is stopped. Failure If the brakes are not used frequently, or if to follow this instruction could result in an ple, the temperature, air humidity, etc.) rust has formed on the disks, it is advisable accident. noises may be produced on braking. to clean off the pads and disks by braking ● If the brake fluid loses its viscosity and is firmly a few times at a moderately high speed subjected to heavy use, vapour bubbles can Wet roads or road salt ››› . form in the brake system. This reduces the ef- In certain situations (for example, on driving ficiency of the brakes. au F lt in the brake system through flooded areas, in severe downpours or after washing the vehicle) the braking ac- If the brake pedal travel should ever increase CAUTION tion could be delayed if the discs and pads suddenly, this may mean that one of the two are damp, or frozen in winter. In this case the ● Never let the brakes “drag” by leaving your brake circuits has failed. Drive immediately brakes should be “dried” by pressing the foot on the pedal when it is not necessary to to the nearest specialised workshop and brake pedal several times. brake. This overheats the brakes, resulting in have the fault repaired. Drive there slowly longer stopping distances and greater wear. and remember that you will have to apply 172

All pages in one PDF file!

How to get the code?
It's very simple! Just pay through a secure PayPal payment.
It will take no longer than a few minutes.
You will receive the code immediately after payment.
The code will be displayed on the screen and will be sent to you by e-mail address.

---

:

How many PDF files you want to download:
1 PDF file $4,00 USD 3 PDF files $8,00 USD 5 PDF files $12,00 USD

- I agree to the terms of service

Site map |
Privacy |
DMCA |
Terms of service
contact e-mail: contact @ man4car.com
All marks are the property of their respective holders