owners manual Seat Ateca

all ratings: 0 average rating: 5

Driving ● “My Beat” Function Electrical components with a high powerWARNING a at consumption are switched off temporarily Never switch off the engine while the vehicle d For vehicles with a convenience key there is when the engine starts. al is moving. This could cause loss of control of the “My Beat” function. This feature provides ● When starting with a cold engine, noise the vehicle, accidents and serious injury. hnic an additional indication of the vehicle igni- levels may briefly increase. This is quite nor- ● ec The airbags and belt tensioners do not tion system. T mal, and no cause for concern. work when the ignition is switched off. ● When the outside temperature is below When accessing the vehicle, e.g. by opening ● The brake servo does not work with the en- +5°C (+41°F), if the engine is diesel, some the doors with the remote control, the gine off. Therefore, you need to press the e smoke may appear under the vehicle when START ENGINE STOP button flashes, calling at- break pedal harder to brake the vehicle. ic the fuel-operated auxiliary heater is on. tention t o the relevant starter system button. ● Power steering does not work when the en- Adv gine is not running. You need more strengthUpon switching the ignition on/off, the light to steer when the engine is switched off.START ENGINE STOP of the button flashes. With Stopping the engine ● If the ignition is switched off, the steeringthe engine switched off, after a few seconds, 3 Valid for vehicles: with Keyless Accesscolumn could be locked, making it impossiblethe STOP ENGINE START button stops flashing to control the vehicle. oe and gs out. ation Switch off the engine with the starter Step With the engine running, the button ››› page 167. Oper CAUTION START ENGINE STOP button light stays on, indi- 1. Stop the vehicle completely ››› . cating that the engine is running. Upon If the engine is made to work hard for a long switching the ignition off with the time, it may overheat after being switched s Press and hold the brake pedal until the step START ENGINE STOP button, it starts flashing 2. off. To prevent damage to the engine before ie 4 is performed. switching it off, leave it idle for approx. 2 mi-again. enc nutes in neutral. g If you are driving an automatic vehicle, place 3. In vehicles with the Start-Stop system, the the selector lever in position P. “My Beat” function also offers additional in- Emer Note Connect the electronic parking brake formation: 4. ››› page 170. After switching off the engine, the cooling fan ●When the engine stops during the Stop may continue to operate in the engine com- Briefly press the start-up button ››› Fig. 164. phase, the light of the START ENGINE STOP but- partment for a few more minutes, even with The START ENGINE STOP button blinks again. If ety 5. on stays on, since, even though the engine t the ignition off. The radiator fan is automati- the engine fails to switch off, perform an emer- Saf is off, the Start-Stop system is active. gency disconnect ››› page 167.cally switched off. ●When the engine cannot be stated again If the vehicle is equipped with a manual gear- 6. ››› with the Start-Stop system, page 188, and box, put it into 1st or reverse. needs to be started manually, the» 169

All pages in one PDF file!

How to get the code?
It's very simple! Just pay through a secure PayPal payment.
It will take no longer than a few minutes.
You will receive the code immediately after payment.
The code will be displayed on the screen and will be sent to you by e-mail address.

---

:

How many PDF files you want to download:
1 PDF file $4,00 USD 3 PDF files $8,00 USD 5 PDF files $12,00 USD

- I agree to the terms of service

Site map |
Privacy |
DMCA |
Terms of service
contact e-mail: contact @ man4car.com
All marks are the property of their respective holders