Alfa Romeo 33 owners manual page 130

text version of content this owner's manual page from owners manual to the vehicle Alfa Romeo 33, year of production 1983 - 1995:

CLUTCH HYDRAULIC CONTROL UNIT CLUTCH PEDAL DISASSEMBLY CHECKS AND INSPECTIONS 1. Remove boot@, remove stop- REMOVAL 1. Inspect pedal and pedal pad for deformation or damage. per ring0, then remove push rod 1. Operating from the interior with fork0, gaskets@ and 0, 2. Inspect bushes of clutch pedal, compartment, remove stopper piston @, pin and spacer for excessive wear orwasher and ring @, and remove pin@ discon- spring @ . @ seizing. necting pedal@ Tram master cyl- 2. Reniove connection 3. Inspect return spring for fatigue 0 and inder control fork0 and return gasket @ . or damage. spring. INSTALLATION Install clutch pedal on car in reverse order of removal and apply grease to bushes of clutch pedal and to master cylinder fork connection pin (AGIP Fl Grease 15). CLUTCH MASTER CYLINDER REMOVAL 1. Remove filler plug0 on 1 Master cylinder7Fork reservoir 0, relevant gasket and 2 Stopper ring 8 Washer 1 Fork 3 Pedal filter then, with a syringe, drain 3 Gasket 9 Spring 2 Pin 4 Stopper ring enough fluid to make level fall below 4 Piston 10 Gasket connection to master cylinder@. 5 Gasket 11 Connection flexible 2. Disconnect SUPPlY 6 Boot hose @ from master cylinder. 2. Operating from the engine room, 3. Loosen connection and discon- remove pedal pin stopper spring@ CHECKS AND INSPECTIONS and relev’antwasher.Unscrew nect rigid pipe@ from master cylinder. screw @ securing the bracket@ 4. Operating from inside the car, for sheath stopper of accelerator remove stopper ring, remove pin and control cable, in order to be ableto CAUTION: disconnect cylinder control fork withdraw pedal pin enough to To clean or wash all parts of master from pedal (see: ClutchPedal - recuperate the clutch pedal from the cylinder, recommended clean brake interior compartment. Removal). fluid must be used. Never use mineral fixing 5. Unscrew screws 0 oils or gasoline and kerosene to avoid master cylinder to pedalassy and damaging rubber parts. then remove master cylinder. 1. Check cylinder bore and piston for score or rust and if found replace. 2. Check cylinder bore and piston for wear. If the clearance between cylinder bore and piston exceeds specifiedvalue,replace piston master cylinder as- assembly or sembly. 3. Check condition of boot and replace it if damaged. 1 Stopper spring3 Screw 4. Check all recesses, openings and 2 Bracket 1 Plug 5 Connection internal passages to ensure that they 2 Flexible pipe6 Rigid pipe are clean and free from foreign 3. Remove the two plastic bushes 3 Screws 7 Reservoir matter. from pedal. 4 Master cvlinder 12-3 May 1983

owners manual Alfa Romeo 33

owners manual Alfa Romeo 33 - year of production: 1983, 1984, 1985, 1986, 1987, 1988, 1989, 1990, 1991, 1992, 1993, 1994, 1995 - Alfa Romeo 33 owners manual EN