Nissan Skyline R34 workshop service manual page 113

text version of content this owner's manual page from owners manual to the vehicle Nissan Skyline, year of production 1998 - 2002:

TCS/ABS SYSTEM Self-diagnostic check ter Self-diagnosis for TCSfABS Control Unit (Terminal 4 of data link c Control System SELF-DIAGNOSIS PROCEDURE 1. Collect information on the concern from the customer, and then perform basic inspections. 2. Drive vehicle at approx. 30 km/h for approx. 1 minute. 3. Stop vehicle and start diagnosis. 4. Turn ignition switch "OFF. Data link connector 5. Ground the self-diagnostic check terminal 4 on the data link for CONSULT connector for CONSULT. 6. Turn ignition switch "ON" to start the self-diagnostic results mode. CAUTION: Keep terminal 4 grounded during self-diagnosis. Do not depress brake pedal. Do not start engine. (Self-diagnosis would not start.) When SLlP indicator lamp does not start blinking, check TCSfABS control unit power supply circuit and ground circuit. 7. The SLlP indicator lamp starts blinking to indicate the malfunc- tion code No. 3 or 4 seconds after the self-diagnostic results mode is started. The indication terminates after 5 minutes. Turning the igni- tion switch from "OFF" to "ON" resumes blinking the indi- cation. During the SLIP indicator lamp operation shown above, TCS OFF indicator lamp and ABS warning lamp are lit. 8. Vsrify the location of the malfunction with "MALFUNCTION CODUSYMPTOM CHART", BR-36. Then make the necessary repairs. 9. After the malfunctions are repaired, erase the malfunction codes stored in the control unit. Refer to "HOW TO ERASE SELF-DIAGNOSTIC RESULTS on the next page. 10. Rerun the self-diagnostic results mode to verify that the mal- function codes have been erased. When the malfunction codes have been erased, the start code is only indicated. 11. Disconnect the check terminal from the ground. The self-diag- nostic results mode is now complete. 12. Drive vehicle at approx. 30 km/h for approx. 1 minute, and then check that the TCS OFF indicator lamp, the SLlP indicator lamp and the ABS warning lamp are OFF. HOW TO READ SELF-DIAGNOSTIC RESULTS (Malfunction codes) Determine the code No. by observing the time and the fre- quency that the SLlP indicator lamp flashes ON and OFF. Refer to the next page. When multiple malfunctions occur at a time, up to three code numbers can be stored; the latest malfunction will be indicated first. The indication begins with the start code No. 12. After that a maximum of three code numbers appear in the order of the latest one first. The indication then returns to the start code No. 12 to repeat. The start code No. 12 is only indicated repeatedly when there is no malfunction.

owners manual Nissan Skyline

owners manual Nissan Skyline - year of production: 1998, 1999, 2000, 2001, 2002 - Nissan Skyline R34 workshop service manual EN