Nissan Skyline R34 workshop service manual page 114

text version of content this owner's manual page from owners manual to the vehicle Nissan Skyline, year of production 1998 - 2002:

TCS/ABS SYSTEM Self-diagnosis for TCS/ABS Control Unit control System (Cont'd) Example: Code No. 25 Front left wheel sensor (open-circutt) lnd~cat~on start Start code No. 12 ABS warnlng lamp - Tens drglts Units drgits Code No. 25 ON I -----l ABS warning lamp -. ----- OFF -------------- I---------- -?-I 3 06 0.9 03C303 3 3 06 3.6 06 09 030303030303030303 Unit: seconds BRG1185D HOW TO ERASE SELF-DIAGNOSTIC RESULTS (Malfunction codes) 1. Turn the ianition switch "ON" and start the engine. 2. Drive the iehicle at approx. 30 km/h for appfox. 1 minute to check that there is no other malfunction. 3. Stop the vehicle and turn the ignition switch "OFF'. I88 4. Ground the self-diagnostic check terminal 4 on the data link connector for CONSULT. 5. Turn the ignition switch "ONn to start the self-diagnostic results /,%@A mode. self-d~agnosts complete i CAUTION: SLlP ndicator lamp I Keep terminal 4 grounded during self-diagnosis. Do not EL ON r f depress the brake pedal during self-diagnosis. Do not start the OFF - c 4 engine. SD i 6. The SLIP indicator lamp starts blinking to indicate the malfunc- tion code No. 3 or 4 seconds after the self-diagnostic results mode is started. ground The indication terminates after 5 minutes. Turning the igni- J Erase -- - - - - - - - - -i - - - - ---f2.i geconds-- - - - - - - t mode tion switch from "OFF" to "ON" resumes blinking the indi- Malfunct~on memory Malfunct~on memory IS cation. During the SLlP indicator lamp operation shown erase mode starts. 1s erased. above, TCS OFF indicator lamp and ABS warning lamp are BRZOO~~D lit. 7. Under the self-diagnostic results mode, the malfunction memory erase mode starts when the check terminal is discon- nected from the ground. 8. Ground the check terminal 3 times or more in succession within 12.5 seconds after the erase mode starts. (Each ground- ing must be 2 seconds or longer.) 9. Disconnect the grounding cable from the check terminal to erase the malfunction memory and complete the self-diagno- sis. 10. Rerun the self-diagnostic results mode to verify that the mal- function codes have been erased. 0 When the malfunction codes have been erased, the start code No. 12 is only indicated. 11. Disconnect the check terminal from the ground. The self-diag- nostic results mode is now complete. 12. Drive vehicle at approx. 30 kdh for approx. 1 minute, and then check that the TCS OFF indicator lamp, the SLlP indicator lamp and the ABS warning lamp are OFF. 13. Turn the ignition switch "OFF.

owners manual Nissan Skyline

owners manual Nissan Skyline - year of production: 1998, 1999, 2000, 2001, 2002 - Nissan Skyline R34 workshop service manual EN