owners manual Nissan Micra

all ratings: 0 average rating: 5

The high beam indicator light also comes onOperationThe MIL may stop blinking and come on steady. whenthepassing signal is activated.The MIL will come on in one of two ways:Havethevehicle inspected by a NISSAN dealer. Malfunction Indicator Light Youdonotneedtohaveyourvehicletowedtothe (MIL) ● MILonsteady—Anemissioncontrolsystemdealer. malfunction has been detected. Check the If this indicator light comes on steady or blinksfuel-filler cap. If the LOOSE FUEL CAPCAUTION while the engine is running, it may indicate awarning message is displayed in the odom-Continued vehicle operation without hav- potential emission control malfunction.eter, and the fuel-filler cap is loose or miss-ing the emission control system checked The may also come on steady if the fuel-ing, tighten or install the cap and continue toand repaired as necessary could lead to filler cap is loose or missing, or if the vehicle runsdrive the vehicle. Thelight should turnpoor driveability, reduced fuel economy, out of fuel. Check to make sure the fuel-filler capoff after a few driving trips. If thelightandpossibledamagetotheemissioncon- is installed and closed tightly, and that the vehicledoes not turn off after a few driving trips,trol system. has at least 3 gal (11.4 L) of fuel in the fuel tank.have the vehicle inspected by a NISSANOverdrive OFF indicator light After a few driving trips, thelight shoulddealer. You do not need to have your vehicle turn off if no other potential emission controltowed to the dealer.(A/T models only) system malfunction exists.● MIL blinking — An engine misfire has beenThis light comes on when the overdrive function If this indicator light comes on steady for 20 sec-detected which may damage the emissionis OFF. onds and then blinks for 10 seconds when thecontrol system. To reduce or avoid emissionThe automatic transmission overdrive function is engine is not running, it indicates that the vehiclecontrol system damage:controlled by the overdrive switch. is not ready for an emission control system inspection/maintenancetest.Foradditionalinfor-– do not drive at speeds above 45 MPHFor additional information, refer to “Driving the mation,referto“Readinessfor(72 km/h); vehicle” in the “Starting and driving” section of inspection/maintenance (I/M) test” in the “Tech-– avoid hard acceleration or deceleration;this manual. nical and consumer information” section of this Security indicator light manual. – avoid steep uphill grades; – if possible, reduce the amount of cargoThis light blinks whenever the ignition switch is being hauled. placed in the LOCK, OFF or ACC position. This function indicates the security system equipped on the vehicle is operational. Instruments and controls 2-11

All pages in one PDF file!

How to get the code?
It's very simple! Just pay through a secure PayPal payment.
It will take no longer than a few minutes.
You will receive the code immediately after payment.
The code will be displayed on the screen and will be sent to you by e-mail address.

---

:

How many PDF files you want to download:
1 PDF file $4,00 USD 3 PDF files $8,00 USD 5 PDF files $12,00 USD

- I agree to the terms of service

Site map |
Privacy |
DMCA |
Terms of service
contact e-mail: contact @ man4car.com
All marks are the property of their respective holders