Alfa Romeo 33 owners manual page 50

text version of content this owner's manual page from owners manual to the vehicle Alfa Romeo 33, year of production 1983 - 1995:

ENGINE MAIN MECHANICAL UNIT 0: Tightening torque 0: Tightening torque Pump body to support re- Belt jockey pulley lock nut (with cold engine) taining screws: 37 f 46 N.m 8-I-10 N-m (3.8 4 4.7kgm (0.8 f 1 kgmm 27.5 + 34 ftalb) 5.8 + 7.2 ftblb) 19. Fit oil pump. (1) Turn crankshaft till piston No. 1 is at Top Dead Center in the com- pression stroke, as mentioned for heads reassembly. (2) Turn the pump drive shaft so that the next rotation, whichWill follow mating of the pump drive gear with that on the crankshaft, will 1 Pump to rear cover retaining screws position the distributor coupling according to the specified p angle.2Pump body to support retaining screw Apply a coating of engine oil to the 1 Rotor arm 3 Distributor shaft drive shaft. (5) Reassemble oil sump with prop-2Distributor lock-coupling er gasket@ and tighten all re- nut taining screws. Before doingSO, Distributor coupling positioning 21. Adjust clearance of intake and p = 22” evenly apply the specified cement toexhaust valves while engine is cold. the gasket (Cement Std. No. 3522-00040 DOW CORNING The relevant procedure is described Silastik 732 RTV). in Group 00 - Engine Maintenance. Before applying the sealant, remove Valve clearance (cold engine): all traces of old sealant and of oil from all surfaces. Intake 0.35 4 0.40 mm (0.0138 + 0.0157 in) Exhaust 0.45 + 0.50 mm (0.0177 + 0.0197in) 22. Fill chambers of camshaft sup- ports with engine oil. Oil quantity required for fill-up 0.250 kg (0.5511 lb) 1 Oil sump2 Gasket in each chamber 20. Fit distributor on rear cover. 23. Fit support covers@ with (I) Turn the distributor’s shaft so 1 Distributor coupling relevant gaskets 0. that the rotor arm@ is positioned on the reference mark stamped on (3) Fit the oil sump pump on rear the distributor’s body. cover and tighten screws0 accord- The rotor arm0 should point ing to specified torque. toward the No. 1 cylinder. This position corresponds to ignition in a: Tightening torque No. 1 cylinder and to correct cou- Oil sump to rear cover re- pling of the oil pump and distributor taining screws shafts. IQ+24 Nhrn (2) If necessary, correct misalign- (1.9 + 2.4kg-m ment of the rotor arm with the 13.7 + 17.4ft+lb) reference mark stamped on the distributor’s body by rotating the (4) Tighten retaining screws@ latter and then tightening the lock between pump body and support nut @ securing the distributor to according to specified torque.the cylinder block rear cover. 1 Cover 2 Gaskets May 1983 01-30

owners manual Alfa Romeo 33

owners manual Alfa Romeo 33 - year of production: 1983, 1984, 1985, 1986, 1987, 1988, 1989, 1990, 1991, 1992, 1993, 1994, 1995 - Alfa Romeo 33 owners manual EN