owners manual Hyundai i30

all ratings: 0 average rating: 5

FDE 7 (IMPORTANT DATA).QXP 7/7/2009 2:52 PM Page 57 Maintenance G201005AUN Tread wear WARNING - Tire age 5. Maximum permissible inflation The tread wear grade is a compara- pressure tive rating based on the wear rate of Tires degrade over time, even This number is the greatest amount when they are not being used. the tire when tested under controlled of air pressure that should be put in conditions on a specified govern- Regardless of the remaining the tire. Do not exceed the maximumment test course. For example, a tire tread, it is recommended that tires generally be replaced afterpermissible inflation pressure. Refer graded 150 would wear one-and-a- to the Tire and Loading Information six (6) years of normal service. half times (1½) as well on the gov- label for recommended inflation Heat caused by not climates or pressure. ernment course as a tire graded 100. frequent high loading condi- The relative performance of tires tions can accelerate the aging depends upon the actual conditions G201006AUN process. Failure to follow this of their use, however, and may 6. Maximum load rating Warning can result in sudden depart significantly from the norm This number indicates the maximum tire failure, which could lead to because of variations in driving load in kilograms and pounds that a loss of control and an acci- habits, service practices and differ- can be carried by the tire. When dent involving serious injury or ences in road characteristics and cli- replacing the tires on the vehicle, death. always use a tire that has the same mate. load rating as the factory installed tire. These grades are molded on the G201004AUN side-walls of passenger vehicle tires. 4.Tire ply composition and material The tires available as standard or G201007BUN optional equipment on your vehicles The number of layers or plies of rub- 7. Uniform tire quality grading may vary with respect to grade. ber-coated fabric are in the tire.Tire Quality grades can be found where manufacturers also must indicate theapplicable on the tire sidewall materials in the tire, which include between tread shoulder and maxi- mum section width. steel, nylon, polyester, and others. The letter "R" means radial ply con- For example: struction; the letter "D" means diago-TREADWEAR 200 nal or bias ply construction; and the TRACTION AA letter "B" means belted-bias ply con- struction. TEMPERATURE A 757

All pages in one PDF file!

How to get the code?
It's very simple! Just pay through a secure PayPal payment.
It will take no longer than a few minutes.
You will receive the code immediately after payment.
The code will be displayed on the screen and will be sent to you by e-mail address.

---

:

How many PDF files you want to download:
1 PDF file $4,00 USD 3 PDF files $8,00 USD 5 PDF files $12,00 USD

- I agree to the terms of service

Site map |
Privacy |
DMCA |
Terms of service
contact e-mail: contact @ man4car.com
All marks are the property of their respective holders