owners manual Subaru Outback

owners manual Subaru Outback - year of production: 2009, 2010, 2011, 2012, 2013, 2014 - Subaru Outback Legacy IV 4 owners manual EN

Document: pdf (18.3 MB) 474 pages

all ratings: 0 average rating: 5

text version of content this owner's manual page from owners manual to the vehicle Subaru Outback, year of production 2009 - 2014:

7-8 Starting and operating NOTE Starting the engine following procedure. Engine oil, engine coolant, brake fluid, (1) Turn the ignition switch to the washer fluid and other fluid levels “LOCK” position and wait for at least should be checked daily, weekly or atCAUTION 10 seconds. After checking that the fuel stops. parking brake is applied, turn the Do not operate the starter motorignition switch to the “START” position continuously for more than 10 sec-while depressing the accelerator pedal onds. If the engine fails to start afterslightly (approximately a quarter of the operating the starter for 5 to 10full stroke). Release the accelerator seconds, wait for 10 seconds orpedal as soon as the engine starts. more before trying again.(2) If this fails to start the engine, turn the ignition switch back to the “LOCK” &MTmodels position and wait for at least 10 seconds. Then fully depress the accel- 1. Apply the parking brake.erator pedal and turn the ignition 2. Turn off unnecessary lights and ac-switch to the “START” position. If the cessories. engine starts, quickly release the 3. Depress the clutch pedal to the flooraccelerator pedal. and shift the shift lever into neutral. Hold(3) If this does not start the engine, the clutch pedal to the floor while startingturn the ignition switch again to the the engine. The starter motor will only“LOCK” position. After waiting for 10 operate when the clutch pedal is de-seconds or longer, turn the ignition pressed fully to the floor.switch to the “START” position without 4. Turn the ignition switch to the “ON”depressing the accelerator pedal. position and check the operation of the(4) If the engine still refuses to start, warning and indicator lights. Refer tocontact your nearest SUBARU dealer “Warning and indicator lights” F3-9.for assistance. 5. Turn the ignition switch to the “START” position without depressing the accelera- tor pedal. Release the key immediately after the engine has started. If the engine does not start, perform the

Download PDF

Click here to download a pdf file with an instruction manual for Subaru Outback
year of production from: 2009

Do you prefer pdf format?
Find out how to download

Enter the code to download PDF file:

All pages in one PDF file!

How to get the code?
It's very simple! Just pay through a secure PayPal payment.
It will take no longer than a few minutes.
You will receive the code immediately after payment.
The code will be displayed on the screen and will be sent to you by e-mail address.