owners manual Skoda Yeti

all ratings: 0 average rating: 5

s2ug.6.book Page 228 Friday, April 9, 2010 2:24 PM 228 Breakdown assistance A B – Align the lifting jack* so that its claw grasps the web of the lower sill at the height – Insert the adapter with its toothed side into the inner toothing of the head of A A of the marking on the plastic cover and the base plate B is resting flat with its the safety wheel bolt A  fig. 180. A A complete surface against firm ground. – Insert the wheel wrench fully onto the adapter B . A – Turn the lifting jack* up further until the wheel is just clear of the ground. – Slacken the wheel bolt, or tighten it firmly  page 227. Ground below the lifting jack which is soft and slippery can cause the vehicle to slip – Reinstall the full wheel trim/wheel cap after removing the adapter or place the cap off the jack. It is therefore always necessary to place the lifting jack* on a solid surface onto the safety wheel bolt. or use a wide and stable base. Use a non-slip base (e.g. a rubber foot mat) if the – Have the tightening torque checked with a torque wrench as soon as possible. surface is smooth, such as cobbled stones, a tiled floor, etc. Steel and light alloy wheels must be tightened to a tightening torque of 120 Nm. WARNING The safety wheel bolts on vehicles fitted with them (one safety wheel bolt per wheel)  Always raise the vehicle with the doors closed - risk of injury! can only be loosened or tighten up by using the adapter provided.  Take suitable measures to prevent the base of the lifting jack from slipping It is meaningful to note the code number hammered into the rear side of the adapter off - risk of injury! or the rear side of the safety wheel bolts. You can obtain a replacement adapter from  Not positioning the lifting jack at the specified points can result in damage an authorised Škoda Service Partner, if necessary, by quoting this number. to the vehicle. The jack can also slip off if it does not have sufficient grip - risk of We recommend that you always carry the adapter for the wheel bolts with you in the injury! vehicle. It should be stowed in the vehicle tool kit.  It is important to support the vehicle with suitable supporting blocks if you wish to work under the lifted vehicle - risk of injury! Caution Damage can occur to the adapter and safety wh eel bolt if the safety wheel bolt is tight- Securing wheels against being stolen* ened up too much. You need a special adapter for slackening the safety wheel bolts. Note The set of safety wheel bolts can be obtained from an authorised Škoda Service Partner. Jump-starting Initial steps Fig. 180 Safety wheel bolt with adapter You can use the battery of another vehicle for jump-starting yours if the engine does not start because the battery on your vehicle is flat. You will require jump-start cables – Pull off the full wheel trim/cap from the wheel hub or cap from the safety wheel for this purpose. bolt.

All pages in one PDF file!

How to get the code?
It's very simple! Just pay through a secure PayPal payment.
It will take no longer than a few minutes.
You will receive the code immediately after payment.
The code will be displayed on the screen and will be sent to you by e-mail address.

---

:

How many PDF files you want to download:
1 PDF file $4,00 USD 3 PDF files $8,00 USD 5 PDF files $12,00 USD

- I agree to the terms of service

Site map |
Privacy |
DMCA |
Terms of service
contact e-mail: contact @ man4car.com
All marks are the property of their respective holders