owners manual Skoda Yeti

all ratings: 0 average rating: 5

s2ug.6.book Page 225 Friday, April 9, 2010 2:24 PM Breakdown assistance225 Changing a wheel Changing a wheel Preliminary work Always change a wheel on a level surface as far as possible. – Take off the full wheel trim*  page226 or the wheel trim cap page227 or the The following steps should be carried out before actually changing the wheel.caps page226. – If it is necessary to change a wheel, park the vehicle as far away as possible from – In the case of light alloy wheels remove the wheel trim cap  page 227. the traffic flow. The place you choose should be level.– First of all slacken the safety wheel bolt * and afterwards the other wheel bolts –Havall the occue pants get out. While changing a wheel, the occupants of the page227. vehicle should not stand on the road (e.g. behind a crash barrier).– Jack up the vehicle until the wheel to be changed is clear of the ground – Apply the handbrake firmly. page227. –Engag1st geare or if your vehicle is fitted with an automatic gearbox, position the – Unscrew the wheel bolts and place them on a clean surface (cloth, paper etc.). selector lever into position P. – Take off the wheel. – If a trailer is coupled, uncouple it. – Fit on the spare wheel and tighten the wheel bolts slightly. –Take thvee hicle tool kit page223 and the spare wheel* page224 out of the – Lower the car. luggage compartment. – Tighten the wheel bolts firmly, alternately and diagonally using the wheel wrench WARNING (crosswise) and last the safety wheel bolt*  page 227.  If you find yourself in flowing traffic switch on the hazard warning lights – Mount the full wheel trim/wheel trim cap or the caps. system and place the warning triangle on the side of the road at the prescribed distance from your vehicle while observing all national legal provisions. In this Note way you are protecting not only yourself but also other road users. All bolts must be clean and must turn easily.  Never start the engine with the vehicle si tting on the raised jack - danger of  You must never grease or oil the wheel bolts! suffering injury.  When fitting on unidirectional tyres, ensure that the tyres rotate in the correct direction page216. Caution If you have to change a wheel on a slope first block the opposite wheel with a stone or Subsequent steps similar object in order to secure the vehicle from unexpectedly rolling away. After changing the wheel, you must perform the following steps. Note – Stow and attach the replaced wheel in the spare wheel well using a special screw Comply with the national legal regulations. page224, fig.175. – Stow the vehicle tool kit in the space provided. – Check the tyre pressure on the spare wheel just mounted as soon as possible. Using the system Safety Driving Tips General MaintenanceBreakdown assistanceTechnical Data

All pages in one PDF file!

How to get the code?
It's very simple! Just pay through a secure PayPal payment.
It will take no longer than a few minutes.
You will receive the code immediately after payment.
The code will be displayed on the screen and will be sent to you by e-mail address.

---

:

How many PDF files you want to download:
1 PDF file $4,00 USD 3 PDF files $8,00 USD 5 PDF files $12,00 USD

- I agree to the terms of service

Site map |
Privacy |
DMCA |
Terms of service
contact e-mail: contact @ man4car.com
All marks are the property of their respective holders