owners manual Seat Mii

all ratings: 0 average rating: 5

Advice 5. Connect the other end of the black jump CAUTION lead X to a solid metal component bolted To avoid considerable damage to the vehicle to the engine block or to the engine block electrical system, note the following careful- itself of the vehicle with the flat battery. ly: Do not connect it to a point near the bat- ● If the jump leads are incorrectly connected, tery A . this could result in a short circuit. 6. Position the leads in such a way that they ● The vehicles must not touch each other, cannot come into contact with any moving otherwise electricity could flow as soon as parts in the engine compartment. the positive terminals are connected. Fig. 134 Diagram of connections for vehicles Starting with Start-Stop system. 7. Start the engine of the vehicle with the How to jump start: description boosting battery and let it run at idling Jump lead terminal connections speed. 1. Switch off the ignition of both vehicles 8. Start the engine of the vehicle with the flat ››› . battery and wait 2 or 3 minutes until the 2. Connect one end of the red jump lead to engine is “running”. the positive + terminal of the vehicle with the flat battery A ››› Fig. 133. Removing the jump leads 3. Connect the other end of the red jump 9. Before you remove the jump leads, switch lead to the positive terminal + in the ve- off the dipped beam headlights (if they hicle providing assistance B . are switched on). 4. For vehicles without Start-Stop system: Fig. 133 Diagram of connections for vehicles 10.Turn on the heater blower and heated rear connect one end of the black jump lead to w w in the vehicle with the flat battery. without Start-Stop system. indo the negative terminal – of the vehicle This helps minimise voltage peaks which providing the current B ››› Fig. 133. are generated when the leads are discon- nected. – For vehicles with Start-Stop system: con- nect one end of the black jump lead X to a 11.When the engine is running, disconnect suitable ground terminal, to a solid piece of the leads in reverse order to the details metal in the engine block, or to the engine given above. block itself ››› Fig. 134. 182

All pages in one PDF file!

How to get the code?
It's very simple! Just pay through a secure PayPal payment.
It will take no longer than a few minutes.
You will receive the code immediately after payment.
The code will be displayed on the screen and will be sent to you by e-mail address.

---

:

How many PDF files you want to download:
1 PDF file $4,00 USD 3 PDF files $8,00 USD 5 PDF files $12,00 USD

- I agree to the terms of service

Site map |
Privacy |
DMCA |
Terms of service
contact e-mail: contact @ man4car.com
All marks are the property of their respective holders