owners manual Seat Mii

all ratings: 0 average rating: 5

Emergencies Fitting the front towline anchorageNote the instructions for towing ››› page 184.Towing advices ation Fitting the towline anchorageTowing requires some experience, especially ific when using a tow rope. Both drivers should ●Take the towline anchorage from the vehi- pec be familiar with the technique required for s cle tool kit in the luggage compartment al towing. For this reason, inexperienced drivers ››› page 172. hnic should abstain. ec ●Press the upper part of the cover ››› Fig. 135 T While driving, avoid excessive traction forces (arrow) to disengage and release the cover. and jerking. When towing on an unpaved ●Remove the cover and leave it hanging road, there is always a risk of overloading from the vehicle. and damaging the anchorage points. e ●Screw in the tow ring into its housing anti- ic If the vehicle is towed, with the hazard warn- Fig. 135 On the right-hand side of the frontclockwise as far as it will go ››› Fig. 136 ››› . Adv ing lights on and the ignition switched on, bumper: Remove the cover. Use a suitable tool to firmly tighten the tow- the turn signal may be used to indicate line anchorage in its location. changes of direction. Simply operate the turn ●After towing, remove the tow ring by turn- signal lever as usual. Meanwhile, the hazard ing it clockwise. warning lights will go off. When the turn sig- ●Place the cover's upper tab on the openingnal lever is returned to the rest position, the of the bumper and carefully guide the lowerhazard warning lights will be turned on auto- ation tab on the edge of the opening. If necessary,matically. press the lower tab from below. Oper Notes for the driver of the towed vehicle ●Press the lower area of the cover until the lower tab engages in the bumper.● Keep the ignition running to prevent the steering wheel from locking and also to allow CAUTION the use of the turn signals, horn, windscreen Fig. 136 On the right-hand side of the front wipers and washers. bumper: Screw in the towline anchorage.The towline anchorage must always be com- pletely and firmly tightened. Otherwise, it● As the power assisted steering does not ety The location for the removable tow ring is oncould be released while towing and tow-start- work if the engine is not running, you will Saf the right-hand side of the front bumper be-ing. need more strength to steer than normally. hind a cover ››› Fig. 135. ●The brake must be depressed must harder The towline anchorage should always be kept as the brake servo does not operate. Avoid in the vehicle. hitting the towing vehicle. » 185

All pages in one PDF file!

How to get the code?
It's very simple! Just pay through a secure PayPal payment.
It will take no longer than a few minutes.
You will receive the code immediately after payment.
The code will be displayed on the screen and will be sent to you by e-mail address.

---

:

How many PDF files you want to download:
1 PDF file $4,00 USD 3 PDF files $8,00 USD 5 PDF files $12,00 USD

- I agree to the terms of service

Site map |
Privacy |
DMCA |
Terms of service
contact e-mail: contact @ man4car.com
All marks are the property of their respective holders