Seat Mii owners manual page 183

text version of content this owner's manual page from owners manual to the vehicle Seat Mii, year of production 2012:

Emergencies 1.4 bar (20 psi / 140 kPa) and higher: s WARNING WARNING ●Set the tyre pressure to the correct value When inflating the wheel, the air compressor Incorrect use of jump leads and incorrectlyation again ››› page 158. ific and the inflator tube may become hot. jump starting could cause the battery to ex- ● plode resulting in serious injury. Please ob-pec ● Carefully resume your journey until you Protect hands and skin from hot parts. s serve the following rules to minimise the risk al reach the nearest specialised workshop with- ● Do not place the hot flexible inflator tube or of a battery explosion: out exceeding 80 km/h (50 mph). hnic hot air compressor on flammable material. ● The battery providing current must haveec T ●Have the damaged tyre replaced. ● Allow them to cool before storing the de- the same voltage (12V) and approximately vice. the same capacity (see markings on battery) WARNING ● If it is not possible to inflate the tyre to at as the flat battery. least 2.0 bars (29 psi / 200 kPa), the tyre isDriving with an unsealed tyre is dangerous ● Never charge a frozen or recently thawed e too badly damaged. The sealant is not in aand can cause accidents and serious injury. ic battery. A flat battery can also freeze at tem- good condition to seal the tyre. Do not con- ● Do not continue driving if the tyre pressureperatures close to 0 °C (+32 °F). Adv tinue driving. Seek specialist assistance. is 1.3 bar (19 psi / 130 kPa) and lower. ● If a battery is frozen and/or has been frozen ● Seek specialist assistance. then it must be replaced. CAUTION ● A highly explosive mixture of gases is re- Switch off the air compressor after a maxi- leased when the battery is being charged. Al- mum of 8 operational minutes to avoid over- ways keep lit cigarettes, flames, sparks and Starting assistance heating! Before switching on the air compres- fire far from the battery. Never use a mobile sor again, let it cool for several minutes. telephone when connecting and removing the ation jump leads. Introduction Oper ● Charge the battery only in well ventilated If the engine fails to start because of a dis- areas given that when the battery is charged Check after 10 minutes of driving charged battery, the battery of another vehi-by outside assistance, it creates a mix of cle can be used to start the engine. Beforehighly explosive gases. ››› 5 Screw in the inflator tube Fig. 132 starting, check the magic eye on the battery ● Jump leads should never enter into contact again and check the pressure on the gauge ››› page 154. with moving parts in the engine compart- 6 . ment. ety F tarting assistance, jump lead cables con- or s ● Never switch the positive and negative 1.3 bar (19 psi / 130 kPa) and lower: forming to the standard DIN 72553 are re- Saf poles or connect the jump leads incorrectly. quired (see the cable manufacturer instruc- ●Stop the vehicle! The tyre cannot be sealed tions). The cable section in vehicles with pet-● Note the instruction manual provided by sufficiently with the tyre mobility set. 2 the manufacturer of the jump leads. rol engine must be at least 25 mm . » ●You should obtain professional assistance ››› . 181

owners manual Seat Mii

owners manual Seat Mii - year of production: 2012 - Seat Mii owners manual EN