owners manual Skoda Rapid

all ratings: 0 average rating: 5

Releasing ›Push the wheel wrench onto the wheel bolt to the stop. 1se the appropriate adapter for undoing the anti-theft wheel bolts » page ĖěĘ. ›Grasp the end of the wrench and turn the bolt about one turn in the direction of the arrow » Fig. Ėěĝ. 0ightening ›Push the wheel wrench onto the wheel bolt to the stop. 1se the appropriate adapter for tightening the anti-theft wheel bolts » page ĖěĘ. Fig. ĖĜĕ Principle sketch: Attach lifting jack ›Grasp the end of the wrench and turn the bolt against the direction of the arrow » Fig. Ėěĝ until it is tight. In order to raise the vehicle, the jack from the tool kit is to be used. After tightening the wheel bolts, the covering caps must be replaced.Position the car jack at the jacking point closest to the flat tyre . 0he mounting points are located on the metal bar of the lower sill on the un- 3ARNING derside of your vehicle. 0he positions of these are embossed by means of If it proves difficult to undo the bolts, carefully apply pressure to the end of markings on the side surface of the lower sill » Fig. ĖěĞ. the wrench with your foot. Keep hold of the vehicle when doing so, and make sure you keep your footing. ›Support the base plate of the jack with its full area resting on level ground and ensure that the jack is located in a vertical position at the jacking point » Fig. ĖĜĕ - . Raising the vehicle ›Position the lifting jack below the jacking point with the crank and move it up until its claw encloses the web » Fig. ĖĜĕ - . Fig. ĖěĞ ›Continue turning up the jack until the wheel is just about lifted off the Jacking points for positioning ground. lifting jack 3ARNING ■ If the wheel has to be changed on a slope, first of all block the opposite wheel with a stone or similar object to prevent the vehicle from unexpect- edly rolling away. ■ Secure the base plate of the lifting jack with suitable means to prevent possible moving. A soft and slippery ground under the base plate may move the lifting jack, causing the vehicle to fall down. It is therefore always nec- essary to place the lifting jack on a solid surface or use a wide and stable base. 1se a non-slip base (e.g. a rubber foot mat) if the surface is smooth, such as cobbled stones, tiled floor, etc. ■ Only attach the lifting jack to the attachment points provided for this pur- pose. ■  Always raise the vehicle with the doors closed. Ėěę Do-it-yourself

All pages in one PDF file!

How to get the code?
It's very simple! Just pay through a secure PayPal payment.
It will take no longer than a few minutes.
You will receive the code immediately after payment.
The code will be displayed on the screen and will be sent to you by e-mail address.

---

:

How many PDF files you want to download:
1 PDF file $4,00 USD 3 PDF files $8,00 USD 5 PDF files $12,00 USD

- I agree to the terms of service

Site map |
Privacy |
DMCA |
Terms of service
contact e-mail: contact @ man4car.com
All marks are the property of their respective holders