owners manual Skoda Rapid

all ratings: 0 average rating: 5

Remove the wheel / fix ĖěĚ ›Loosen the retaining belt and take out the box with the tool kit. ›1nscrew the nut in direction of arrow » Fig. ĖěĚ. Follow-up work ĖěĚ ›0ake out the wheel. For your own safety and the safety of the passengers, the following instruc- Stow the wheel tions must be observed before changing a wheel on the road. ›Place the wheel into the wheel well with the wheel rim pointing downward.  Switch on the hazard warning lights system.  Place the warning triangle at the prescribed distance. On vehicles with the vehicle battery in the boot, lay down the wheel with the outer face upward.  Park the vehicle as far away as possible from the flowing traffic.  Choose a location with a flat, solid surface. ›Pull the fixing band through the opposite holes in the wheel rim.  Have all the occupants get out. 0he passengers should not stand on the›Screw on the nut in the opposite direction to the arrow » Fig. ĖěĚ until the road (instead they should remain behind a crash barrier, for instance) whilewheel is safely secured. the wheel is being changed. ›Replace the box with the tool kit into the emergency or spare wheel and se- cure it with the tape. ›Fold back the floor in the luggage compartment. Preliminary work ›Close the boot lid. Before changing the wheel, the following work must be carried out. Full wheel trim ›Switch off the engine. ›For vehicles with manual transmission select gear Ė. Before removing the wheel bolts, remove the wheel cover. ›On vehicles with automatic transmission, place the selector lever in the P position. Removing ›Firmly apply the handbrake. Hook the clamp found in the vehicle tool kit » page ĖěĖ into the reinforced › ›1ncouple trailer, if attached. edge of the wheel trim. ›Push the wheel wrench through the clamp, support on the tyre and pull off the wheel trim. Removing/stowing the wheel Installing Fig. ĖěĚ ›Press the wheel trim onto the wheel rim at the designated valve opening. 0ake out the wheel ›0hen press the trim into the wheel rim until its entire circumference locks correctly in place. Notes from the factory or from the ŠKODA Original accessory delivered trim. ▶ 3hen using an anti-theft wheel bolt, make sure that this has been fitted ac- cording to the position marked on the back of the wheel cover position. ▶ On the back of the wheel cover, the position for the anti-theft wheel bolt is marked by means of a symbol. If the wheel cover is set outside the position marked for the anti-theft wheel bolt, there is a risk of damaging the wheel 0he spare wheel is located in a well under the floor covering in the boot and is cover. fixed in place with a special bolt » Fig. ĖěĚ. If wheel trims are fitted, an adequate flow of air must be assured in order to 0ake out the wheel  cool the brake system. ›Open the boot lid. ›Lift up the floor in the luggage compartment. Ėěė Do-it-yourself

All pages in one PDF file!

How to get the code?
It's very simple! Just pay through a secure PayPal payment.
It will take no longer than a few minutes.
You will receive the code immediately after payment.
The code will be displayed on the screen and will be sent to you by e-mail address.

---

:

How many PDF files you want to download:
1 PDF file $4,00 USD 3 PDF files $8,00 USD 5 PDF files $12,00 USD

- I agree to the terms of service

Site map |
Privacy |
DMCA |
Terms of service
contact e-mail: contact @ man4car.com
All marks are the property of their respective holders