owners manual Mitsubishi Eclipse

all ratings: 0 average rating: 5

2-42 POWER TRAIN- Automatic Transaxle CLUTCH All flve clutches in theF4ACl transaxle are applied clutches. With the exception of direct gear, one input hydraulically. Four of the clutches are released with belleville springs, and one is released with a coilclutch and one holding clutch must be applied to d obtain a gear range. In direct gear, two input clutches spring. Three of the clutches supply input power are applied and basically connect the input and to the planetary geartrain and are called input output shafts together. This causes the entiregear- clutches. The other two clutches hold components set to rotate as one with no relative motion between of the planetary geartrain and are called holding planetary gearset components. Input Clutch Assemblies Overdrive/Reverse Diston 1 The input clutch assembly is located directly behind the oil m-f-q f&drive1 pump housing, and rides on the reaction shaft support journal. The assembly consists of an input shaft, input hub, clutch retainer, clutch pistons, an overdrive hub, an underdrive hub C and three input clutches. The clutches are the underdrive clutch, overdrive clutch and reverse clutch. When the torque converter u/ljjU$lerdrive turbine (which is splined to the input shaft) turns, the input It hub~ shaft, hub, and clutch retainer also turn. Underdrive hub Underdrive Clutch Hub The underdrive clutch is splined to the underdrive hub assembly. rdrive The underdrive hub and shaft assembly is splined to the rear sun gear. When the underdrive clutch is applied the rear sun gear is driven (rotated). d #3 thrust washer I #3 thrust Overdrive Overdrive Hub plate The overdrive clutch is splined to the overdrive hub assembly and the overdrive hub is splined to the front carrier assembly. The reverse clutch is splined to the front sun gear assembly and rotates it when applied. Overdrive Input Clutches Each of the three clutches, in the input clutch assembly, have the job of supplying input power to a particular component in the planetary gearset when they are hydraulically applied. I They are connected to the planetarygearset through the over- drive hub and shaft assembly, the underdrive hub and shafta assembly, and the front sun gear assembly. When any of these clutches are applied, they turn or drive a component in the planetary gearset.

All pages in one PDF file!

How to get the code?
It's very simple! Just pay through a secure PayPal payment.
It will take no longer than a few minutes.
You will receive the code immediately after payment.
The code will be displayed on the screen and will be sent to you by e-mail address.

---

:

How many PDF files you want to download:
1 PDF file $4,00 USD 3 PDF files $8,00 USD 5 PDF files $12,00 USD

- I agree to the terms of service

Site map |
Privacy |
DMCA |
Terms of service
contact e-mail: contact @ man4car.com
All marks are the property of their respective holders