owners manual Mercedes SL

all ratings: 0 average rating: 5

Features 537 XPressandholdoneofbuttons;to?on Synchronizing the rolling code the integrated garage door opener. Observe the "Important safety notes" After a short time, indicator lamp : lights(Y page 536). upyellow. Your vehicle must be within reach of the iIndicatorlamp:lightsupyellowassoongaragedoororexteriorgatedrive.Makesure that neither your vehicle nor any persons/ as button ;, = or ? is programmed for objects are present within the sweep of the the first time. If the selected button has door or gate. already been programmed, indicator lamp :will only light up yellow after tenXTurntheSmartKeytoposition2inthe seconds have elapsed. ignition lock. XPresstheprogrambuttonofthedooror XReleasebutton ;,=or?.Indicator gate drive (see the door or gate drive lamp :flashes yellow. operating instructions, e.g. under XPoint garage door remote control A "programming of additional remote towards buttons ; to ? on the rear-view controls"). features mirror at a distance of 2 to 8 inches (5 to iUsually,younowhave30secondsto 20cm). initiate the next step. and iTherequireddistancebetweenremote XPresspreviously programmed button ;, control A and the integrated garage door =or?oftheintegratedgaragedoor opener depends on the garage door drive opener until the door closes. system. Several attempts might be The rolling code synchronization is then necessary. You should test every position Stowage complete. for at least 25 seconds before trying another position. Notesonprogrammingtheremote XPressandholdbuttonBonremotecontrol control Auntilindicator lamp : lights up green. Canadian radio frequency laws require a If indicator lamp : lights up green or "break" (or interruption) of the transmission flashes, then programming has beensignals after broadcasting for a few seconds. successful. Therefore, these signals may not last long X enough for the integrated garage door ReleasebuttonBonremotecontrolAfor opener. The signal is not recognized during the garage door drive system. programming. Comparable with Canadian XIf indicator lamp : lights up red: repeat law, some U.S. garage door openers also the programming procedure for the feature a "break". corresponding button on the rear-view Proceed as follows: mirror. When doing so, vary the distance between remote control A and the rear-R if you live in Canada view mirror. R if you have difficulties programming the garage door opener (regardless of where iIftheindicator lamp flashes green after you live) when using the programming successful programming, the garage door steps system is using a rolling code. After programming, you must synchronize the garage door opener integrated in the rear- view mirror with the receiver of the garage door system. Z

All pages in one PDF file!

How to get the code?
It's very simple! Just pay through a secure PayPal payment.
It will take no longer than a few minutes.
You will receive the code immediately after payment.
The code will be displayed on the screen and will be sent to you by e-mail address.

---

:

How many PDF files you want to download:
1 PDF file $4,00 USD 3 PDF files $8,00 USD 5 PDF files $12,00 USD

- I agree to the terms of service

Site map |
Privacy |
DMCA |
Terms of service
contact e-mail: contact @ man4car.com
All marks are the property of their respective holders