owners manual Mercedes SL

all ratings: 0 average rating: 5

538 Features XPressandholdoneofbuttons;to?on sameprogrammingstepswiththis remote the integrated garage door opener.control. Before performing these steps, After a short time, indicator lamp : lightsmakesurethatnewbatteries have been installed in garage door drive remote upyellow. control A. XReleasethebutton. R Note that some remote controls only Indicator lamp : flashes yellow. transmit for a limited amount of time (the XPressbuttonBofgaragedoorremote indicator lamp on the remote control goes control A for two seconds, then release it out). Press button B on remote control for two seconds. Aagainbeforetransmission ends. XPressbuttonBagainfortwoseconds. R Align the antenna cable of the garage door XRepeatthis sequence on button B of opener unit. This can improve signal remote control A until indicator lamp : reception/transmission. lights up green. If indicator lamp : turns red, repeat the Opening/closing the garage door features process. After it has been programmed,theintegrated XContinuewith the other programming and garage door opener performs the function of steps (see above). the garage door system remote control. Please also read the operating instructions Problemswhenprogramming for the garage door system. If you are experiencing problems XTurntheSmartKeytoposition2inthe programming the integrated garage door Stowage ignition lock. opener on the rear-view mirror, take note of the following instructions: XPressbutton;,=or?whichyouhave programmedtooperatethegaragedoor. R Checkthetransmitter frequency of garage Garage door system with a fixed code: door drive remote control A. This can indicator lamp : lights up green. usually be found on the back of the remote Garage door system with a rolling code: control. indicator lamp : flashes green. The integrated garage door opener is compatible with devices that have unitsiThetransmitterwill transmit a signal as which operate in the frequency range oflong as the button is pressed. The 280to 433MHz. transmission is halted after a maximum of R ten seconds and indicator lamp : lights Replace the batteries in garage door remote control A. This increases theupyellow. Press button ;, = or ? again likelihood that garage door remote controlif necessary. Awilltransmitastrongandprecisesignal totheintegratedgaragedooropenerintheClearing the memory rear-view mirror. XTurntheSmartKeytoposition2inthe R Whenprogramming,holdremotecontrol ignition lock. Aatvaryingdistancesandanglesfromthe XPressbuttons ;and?. button that you are programming. Try The indicator lamp lights up yellow. various angles at a distance between 2and XPressandholdbuttons;and?untilthe 12inches(5to30cm)oratthesameangle indicator lamp turns green. but at varying distances. R If another remote control for the same garage door drive is available, repeat the

All pages in one PDF file!

How to get the code?
It's very simple! Just pay through a secure PayPal payment.
It will take no longer than a few minutes.
You will receive the code immediately after payment.
The code will be displayed on the screen and will be sent to you by e-mail address.

---

:

How many PDF files you want to download:
1 PDF file $4,00 USD 3 PDF files $8,00 USD 5 PDF files $12,00 USD

- I agree to the terms of service

Site map |
Privacy |
DMCA |
Terms of service
contact e-mail: contact @ man4car.com
All marks are the property of their respective holders