owners manual Mercedes CL

owners manual Mercedes CL - year of production: 2006 - Mercedes Benz CL C216 owners manual EN

Document: pdf (20.48 MB) 723 pages

all ratings: 0 average rating: 5

text version of content this owner's manual page from owners manual to the vehicle Mercedes CL, year of production 2006:

Controls in detail Useful features If you live in Canada or if you are having iUpon completion of programming the inte-Operation of integrated remote control difficulties programming a gate operator grated remote control, make sure you retain the Switch on the ignition ( page 336). (regardless of where you live) by using the hand-held remote control that came with the ga- programming procedures, replace step 4 rage door opener, gate operator or other device. Select and press the appropriate inte- with the following: You may need it for use in other vehicles, for fu-grated signal transmitter button (2, ture programming of an integrated remote con-3 or4) to activate the remote con- Step 4: trol, or simply for continued use as a hand-held trolled device. Press and hold the signal transmitter remote control to operate the respective device button (2, 3 or4). Do not release in other situations. The integrated remote control trans- this button until it has been successful- mitter continues to send the signal as ly trained. Reprogramming a single signal trans-long as the button is pressed – up to mitter button 20seconds. While still holding down the signal To program a device using a signal trans- transmitter button (2, 3 or 4), mitter button previously trained, follow Erasing integrated remote control “cycle” your hand-held remote control these steps: memory button 6 as follows: Press and hold Switch on the ignition ( page 336). button 6 for 2 seconds, then release Switch on the ignition ( page 336). it for 2 seconds, and again press and Press and hold the desired signal Simultaneously press and hold outer hold it for 2 seconds. Repeat this se-transmitter button (2, 3 or 4). signal transmitter buttons 2 and 4, quence on the hand-held remote con-Donot release the button. for approximately 20 seconds, until trol until the frequency signal has been indicator lamp 1 flashes rapidly. Do learned. Upon successful training, indi- Indicator lamp 1 will begin to flash af-not hold for longer than 30 seconds. cator lamp 1 will flash slowly and then ter 20 seconds. Without releasing the The codes of all three channels are rapidly after several seconds.signal transmitter button, proceed with erased. programming starting with step 3. Proceed with programming step 5 and iIf you sell your vehicle, erase the codes of all step 6 to complete. three channels. 494

Download PDF

Click here to download a pdf file with an instruction manual for Mercedes CL
year of production from: 2006

Do you prefer pdf format?
Find out how to download

Enter the code to download PDF file:

All pages in one PDF file!

How to get the code?
It's very simple! Just pay through a secure PayPal payment.
It will take no longer than a few minutes.
You will receive the code immediately after payment.
The code will be displayed on the screen and will be sent to you by e-mail address.