owners manual Mercedes GL

all ratings: 0 average rating: 5

Features 365 Garage door remote control A is notnecessary. You should test every position included with the integrated garage doorfor at least 25 seconds before trying opener. another position. XTurntheSmartKeytoposition 2 in the Synchronizing the rolling code ignition lock (Y page 167). Payattention to the "Important safety notes" XSelect one of buttons ; to ? to use to (Y page 364). control the garage door drive. If the garage door systemusesarollingcode, XTostartprogramingmode:pressand you will also have to synchronize the garage s hold one of buttons ; to ? of the door system with the integrated garage door re integrated garage door opener. openerintherear-viewmirror.Todothisyou tu The garage door opener is now in will needtousetheprogramingbuttononthe programing mode. After a short time, door drive control panel. The programing fea indicator lamp : lights up yellow. button may be placed at different locations Indicator lamp : lights up yellow as soondepending on the manufacturer. It is usually and located on the door drive unit on the garage asbutton;,=or?isprogramedforthe ceiling. first time.Iftheselectedbuttonhasalready been programed, indicator lamp : willFamiliarize yourself with the garage door owage drive operating instructions, e.g. under only light up yellow after ten seconds have "Programing of additional remote controls",St elapsed. before carrying out the following steps. XReleasebutton ;,=or?.Indicator Your vehicle must be within reach of the lamp :flashes yellow. garagedoororexteriorgatedrive.Makesure XToprogramtheremotecontrol:point that neither your vehicle nor any persons/ garage door remote control A towards objects are present within the sweep of the buttons;to?ontherear-viewmirrorat door or gate. a distance of 2 to 8 inches (5 to 20 cm). XTurntheSmartKeytoposition 2 in the XPressandholdbuttonBonremotecontrol ignition lock (Y page 167). Auntilindicator lamp : lights up green. XGetoutofthevehicle. Whenindicator lamp : lights up green: XPresstheprogramingbutton on the door programing is finished. drive unit. Whenindicator lamp : flashes green: Usually, you now have 30 seconds to programing was successful. The next step initiate the next step. is to synchronize the rolling code. XGetintothevehicle. XReleasebuttonBonremotecontrolAfor XPresspreviously programed button ;, = the garage door drive system. or ?oftheintegratedgaragedooropener If indicator lamp : lights up red: repeat until the door closes. the programing procedure for the The rolling code synchronization is then corresponding button on the rear-view complete. mirror. When doing so, vary the distance between remote control A and the rear- Notesonprogramingtheremotecontrol view mirror. Canadian radio frequency laws require a The required distance between remote "break" (or interruption) of the transmission control A and the integrated garage door signals after broadcasting for a few seconds. opener depends on the garage door drive Therefore, these signals may not last long system. Several attempts might be enoughfor the integrated garage door Z

All pages in one PDF file!

How to get the code?
It's very simple! Just pay through a secure PayPal payment.
It will take no longer than a few minutes.
You will receive the code immediately after payment.
The code will be displayed on the screen and will be sent to you by e-mail address.

---

:

How many PDF files you want to download:
1 PDF file $4,00 USD 3 PDF files $8,00 USD 5 PDF files $12,00 USD

- I agree to the terms of service

Site map |
Privacy |
DMCA |
Terms of service
contact e-mail: contact @ man4car.com
All marks are the property of their respective holders