owners manual Mercedes GL

all ratings: 0 average rating: 5

366 Features opener. The signal is not recognized duringProblemswhenprograming programing. Comparable with Canadian law, If you are experiencing problems programing someU.S.garagedooropenersalsofeature the integrated garage door opener on the a "break". rear-view mirror, take note of the following Proceed as follows: instructions: R R if you live in Canada Checkthetransmitter frequency used by R garage door drive remote control A and if you have difficulties programing the whether it is supported. The transmitter garage door opener (regardless of where frequencycanusuallybefoundontheback you live) when using the programing steps of the garage door drive remote control. XPressandholdoneofbuttons;to?on The integrated garage door opener is the integrated garage door opener. compatible with devices that have units After a short time, indicator lamp : lights features which operate in the frequency range of upyellow. 280to433MHz. XReleasethebutton. and R Replace the batteries in garage door Indicator lamp : flashes yellow. remote control A. This increases the XPressbuttonBofgaragedoorremote likelihood that garage door remote control control A for two seconds, then release it Awilltransmitastrongandprecisesignal for two seconds. Stowage totheintegratedgaragedooropenerinthe XPressbuttonBagainfortwoseconds. rear-view mirror. XRepeatthis sequence on button B ofR Whenprograming, hold remote control A remote control A until indicator lamp : at varying distances and angles from the lights up green. buttonthatyouareprograming.Tryvarious Whenindicator lamp : lights up green:angles at a distance between 2and programing is finished. 12inches(5to30cm)oratthesameangle but at varying distances. Whenindicator lamp : flashes green: R If another remote control for the same programing was successful. The next step garage door drive is available, repeat the is to synchronize the rolling code. sameprogramingsteps with this remote XReleasebuttonBofremotecontrolAof control. Before performing these steps, the garage door drive. makesurethatnewbatteries have been If indicator lamp : blinks red: repeat the installed in garage door drive remote programing process for the corresponding control A. buttonontherear-viewmirror.Whendoing R Note that some remote controls only so, vary the distance between remote transmit for a limited amount of time (the control A and the rear-view mirror. indicator lamp on the remote control goes The required distance between remote out). Press button B on remote control control A and the integrated garage door Aagainbeforetransmission ends. opener depends on the garage door drive R Align the antenna cable of the garage door system. Several attempts might be opener unit. This can improve signal necessary. You should test every position reception/transmission. for at least 25 seconds before trying another position.

All pages in one PDF file!

How to get the code?
It's very simple! Just pay through a secure PayPal payment.
It will take no longer than a few minutes.
You will receive the code immediately after payment.
The code will be displayed on the screen and will be sent to you by e-mail address.

---

:

How many PDF files you want to download:
1 PDF file $4,00 USD 3 PDF files $8,00 USD 5 PDF files $12,00 USD

- I agree to the terms of service

Site map |
Privacy |
DMCA |
Terms of service
contact e-mail: contact @ man4car.com
All marks are the property of their respective holders