owners manual Nissan Murano

all ratings: 0 average rating: 5

Black plate (354,1) DRIVING THE VEHICLE GUID-874DAAA4-503F-461F-8A66-BEEC6486BBB0 depressing the brake pedal and pushing CONTINUOUSLY VARIABLE TRANS- 2. Keep the foot brake pedal depressed and the push-button ignition switch to start MISSION (CVT) move the selector lever to a driving position. the engine. If the engine starts, but fails GUID-ACCD68EB-D536-48ED-BBB3-82DB1D8F06BA3.Release the parking brake and foot brake to run, repeat the above procedure. The Continuously Variable Transmission (CVT) in your vehicle is electronically controlled to pedal, and then gradually start the vehicle in produce maximum power and smooth operation. motion. CAUTION Therecommendedoperatingproceduresforthis transmission are shown on the following pages. WARNING Do not operate the starter for more Follow these procedures for maximum vehicle than 15 seconds at a time. If the engine performance and driving enjoyment. . Do not depress the accelerator does not start, push the ignition switch Engine power may be automatically re- pedal while shifting from P (Park) to OFF and wait 10 seconds before duced to protect the CVT if the engine or N (Neutral) to R (Reverse), D cranking again, otherwise the starter speed increases quickly when driving on (Drive) or L (Low) position. Always could be damaged. slippery roads or while being tested on depress the brake pedal until shift- some dynamometers. ing is completed. Failure to do so 4. Warm-up could cause you to lose control and Starting the vehicle have an accident. Allow the engine to idle for at least 30 GUID-35972EF7-F09E-4D7E-99A4-08117777767B seconds after starting. Do not race the 1. After starting the engine, fully depress the . Cold engine idle speed is high, so engine while warming it up. Drive at foot brake pedal before moving the selector use caution when shifting into a moderate speed for a short distance first, lever out of the P (Park) position. forward or reverse gear before the especially in cold weather. In cold weather, This CVT is designed so that the foot engine has warmed up. keeptheenginerunningforaminimumof2- brake pedal must be depressed before . Never shift to P (Park) or R (Re- 3minutes before shutting it off. Starting and shifting from P (Park) to any driving verse) while vehicle is moving. Fail- stopping the engine over a short period of position while the ignition switch is in ure to do so could cause you to lose time may make the vehicle more difficult to the ON position. control and have an accident. start. Theselectorlevercannotbemovedout 5. To stop the engine, shift the selector lever to of the P (Park) position and into any of the P (Park) position and push the ignition the other positions if the ignition switch to the OFF position. switch is pushed to the LOCK, OFF or ACCposition. 5-14 Starting and driving [ Edit: 2011/ 7/ 18Model: Z51-D ]

All pages in one PDF file!

How to get the code?
It's very simple! Just pay through a secure PayPal payment.
It will take no longer than a few minutes.
You will receive the code immediately after payment.
The code will be displayed on the screen and will be sent to you by e-mail address.

---

:

How many PDF files you want to download:
1 PDF file $4,00 USD 3 PDF files $8,00 USD 5 PDF files $12,00 USD

- I agree to the terms of service

Site map |
Privacy |
DMCA |
Terms of service
contact e-mail: contact @ man4car.com
All marks are the property of their respective holders