Alfa Romeo 33 owners manual page 35

text version of content this owner's manual page from owners manual to the vehicle Alfa Romeo 33, year of production 1983 - 1995:

ENGINE MAIN MECHANICAL UNIT 9. Complete the unit assemblprescribed oil: e Summer carrying out the disassembly opera- Potable water Engine oil tions in reverse order, with particular AGIP Sint 2000lOW50 attention to the following steps. Winter IP Super Motor OillOW50 (I) By means of a spanner, tighten Antifreeze (See Unit 07- to the prescribed indicative torque, General Directives) Gearbox oil differential: the union connecting hose to clutch AGIP Fl Rotra HP SAESOW90 control pipe. IP Pontiax HDSOW90 (5) Adjust the accelerator cable (See Unit 04 Accelerator Wire Adjust- indicative torque merit). 0: Tightening (3) Bleed the clutch hydraulic relevant to hose union to pipe. (6) With the engine at running heat, 15 + 19 N.m system (See Unit 12- Hydraulic check its idling. For any tuning up System Bleeding) and if necessary (1.5 + 1.9 kg-m required,see Unit 00 Engine top up the oil level to the MAX mark 10.84 + 13.78ft.lb) Maintenance - Ignition and Feed on the tank with the prescribed fluid System. (AGIP Fl Brake Fluid Super HD or (2) CheckThe engine oil level IP Auto FluidFR). c&responds to the MAX mark on the (4) Top up the coolant with the dipstick, and the gearbox oil level prescribed liquid. reaches the lower edge of the filler hole. If necessary, top up with the SEPARATION AND ASSEMBLY OF THE UNITS SEPARATION ASSEMBLY With the drive unit on the rotatory 1. Lubricatethe direct drive shaft 2. Remove the lower cover@ stand fitted with suitable supporting working seat with the prescribed protecting the engine flywheel after equipment, separate the engine unit grease (Grease Molykote paste G). disassembling the screws and wash- from the gearbox unit for the pur- ers 2 securing the lower cover to2. Perform assembly operations in 0 pose of replacement or overhaul of the engine rear cover and to thethe reverse order to the separation, the two units and of the clutch, as gearbox. tightening connecting nuts and bolts follows: 3. Unscrew and remove the remain- to the prescribed torque. 1. Unscrew and take off the nuts ing nuts and washers@ and com- and washers@ from the starter plete the separation of the two units. 0: Tightening torque motor 0 securing screws Nuts and bolts connecting the 0 and remove the starter motor fromWithdraw the thrust beating from its two units the engine unit. support on the gearbox so as not to 39 + 48 N-m (4 + 4.9 kg-m 28.92 + 35.43ft.lb) 1 Nut andwasher 3 Starter motor 1 Lower cover 3 Nutand washer 2 Screw 2 Screwand washer 01-Q May 1983

owners manual Alfa Romeo 33

owners manual Alfa Romeo 33 - year of production: 1983, 1984, 1985, 1986, 1987, 1988, 1989, 1990, 1991, 1992, 1993, 1994, 1995 - Alfa Romeo 33 owners manual EN