owners manual Skoda Kodiaq

all ratings: 0 average rating: 5

Starting engine 3ARNING (Continued) ›Start the engine on the vehicle providing the power and allow it to idle. ■ A discharged vehicle battery may already freeze at temperatures just be- ›Start the engine in the vehicle with the discharged battery. low ĕ °C. If the battery is frozen, do not carry out a jump start with the bat- ›If the engine does not start within Ėĕ s, then cancel the starting procedure tery of another vehicle – risk of explosion! and repeat after half a minute. ■ Never jump-start vehicle batteries with an acid level that is too low – risk ›Remove the jump start cables in the reverse order as attachment. of explosion and caustic burns! 3ARNING ■ Never clamp the jump-start cable to the negative terminal of the dis- Jump-starting using the battery from another vehicle charged battery - danger of explosion. ■ 0he non-insulated parts of the terminal clamps must never touch each other – risk of short circuit! ■ 0he jump-start cable connected to the positive terminal of the battery must not come into contact with electrically conducting parts of the vehicle – risk of short circuit! ■ Route the jumper cables so that they cannot be caught in rotating parts in the engine compartment - danger of injuries and the risk of vehicle dam- age. Fig. ĘĚĕ Jump-starting:  - Discharged battery,  - power-supplying bat-0owing the vehicle tery / ground point of the engine for the S0AR0-S0OP system Information about the towing process Read and observe on page ėĞĜ first. If it is not possible to start the engine due to a discharged vehicle battery, the battery of another vehicle can be used to start the engine. Only use jump-start cables which have an adequately large cross-section and insulated terminal clamps. 0he rated voltage of the two batteries must be Ėė2. 0he capacity (Ah) of the current-giving battery must not be significantly less than the capacity of the discharged battery in your vehicle. 0he jump-start cables must be attached in the following sequence. ›Attach clamp Ė to the positive terminal of the discharged battery.Fig. ĘĚĖ Braided tow rope / Spiral tow rope ›Attach clamp ė to the positive terminal of the current-giving battery. Attach clamp Ę to the negative terminal of the current-giving battery.For towing using a tow rope, use only a braided synthetic fibre rope » Fig. ĘĚĖ - › For vehicles with the S0AR0-S0OP system, secure the clamp ę to the » . › ground point of the engine A » Fig. ĘĚĕ. Attach the tow rope or the tow bar to thetowing eyes at the front ›For vehicles without the S0AR0-S0OP system, secure the clamp ę to a solid » page ėĞĞ, towing eyes at the rear» page Ęĕĕor to thetowing device of the metal part that is firmly attached to the engine block or secure to the engine  trailer device » page ėěĖ. block directly. ėĞĝ Do-it-yourself

All pages in one PDF file!

How to get the code?
It's very simple! Just pay through a secure PayPal payment.
It will take no longer than a few minutes.
You will receive the code immediately after payment.
The code will be displayed on the screen and will be sent to you by e-mail address.

---

:

How many PDF files you want to download:
1 PDF file $4,00 USD 3 PDF files $8,00 USD 5 PDF files $12,00 USD

- I agree to the terms of service

Site map |
Privacy |
DMCA |
Terms of service
contact e-mail: contact @ man4car.com
All marks are the property of their respective holders