owners manual Seat Leon

all ratings: 0 average rating: 5

Emergencies 285 6. Position the leads in such a way that they cannot come into WARNING contact with any moving parts in the engine compartment. ● Please note the safety warnings referring to working in the engine Starting compartment ⇒ page 251. 7. Start the engine of the vehicle with the boosting battery and let ● The battery providing assistance must have the same voltage as the flat battery (12V) and approximately the same capacity (see imprint on it run at idling speed. battery). Failure to comply could result in an explosion. 8. Start the engine of the vehicle with the flat battery and wait two ● Never use jump leads when one of the batteries is frozen. Danger of or three minutes until the engine is “running”. explosion! Even after the battery has thawed, battery acid could leak and cause chemical burns. If a battery freezes, it should be replaced. Removing the jump leads ● Keep sparks, flames and lighted cigarettes away from batteries, dan- ger of explosion. Failure to comply could result in an explosion. 9. Before you remove the jump leads, switch off the dipped beam ● Observe the instructions provided by the manufacturer of the jump headlights (if they are switched on). leads. 10.Turn on the heater blower and heated rear window in the vehi- ● Do not connect the negative cable from the other vehicle directly to cle with the flat battery. This helps minimise voltage peaks the negative terminal of the flat battery. The gas emitted from the battery which are generated when the leads are disconnected. could be ignited by sparks. Danger of explosion. ● Do not attach the negative cable from the other vehicle to parts of the 11.When the engine is running, disconnect the leads in reverse or- fuel system or to the brake line. der to the details given above. ● The non-insulated parts of the battery clamps must not be allowed to touch. The jump lead attached to the positive battery terminal must not Connect the battery clamps so they have good metal-to-metal contact with touch metal parts of the vehicle, this can cause a short circuit. the battery terminals. ● Position the leads in such a way that they cannot come into contact If the engine fails to start, switch off the starter after about 10 seconds andwith any moving parts in the engine compartment. try again after about half a minute. ● Do not lean on the batteries. This could result in chemical burns. Note The vehicles must not touch each other, otherwise electricity could flow as  soon as the positive terminals are connected. Safety First Operating instructions Practical Tips Technical specifications

All pages in one PDF file!

How to get the code?
It's very simple! Just pay through a secure PayPal payment.
It will take no longer than a few minutes.
You will receive the code immediately after payment.
The code will be displayed on the screen and will be sent to you by e-mail address.

---

:

How many PDF files you want to download:
1 PDF file $4,00 USD 3 PDF files $8,00 USD 5 PDF files $12,00 USD

- I agree to the terms of service

Site map |
Privacy |
DMCA |
Terms of service
contact e-mail: contact @ man4car.com
All marks are the property of their respective holders