owners manual Skoda Kodiaq

all ratings: 0 average rating: 5

CA10ION CA10ION Do not cover the radiator or fit any parts (e.g. auxiliary lights) in front of the air■ If the expansion tank is empty, do not top up with coolant. 0he system could intakes - there is a risk of the engine overheating. aerate - risk of damaging the engine!  Stop driving! Switch off the engine and seek assistance from a specialist garage. ■ Do not fill the coolant above the mark A » Fig. ĘĘĘ. 3hen it heats up, the Checking and refilling coolant could press out of the cooling system - there is a risk of damage to the engine parts. Fig. ĘĘĘ ■ If it is not possible to add coolant,  stop driving! Switch off the engine and Coolant expansion reservoir seek assistance from a specialist garage. ■ A coolant additive which does not correspond to the correct specification can reduce the anti-corrosion effect of the cooling system - there is a risk of dam- age to the cooling system and the engine. ■ If water other than distilled (demineralised) water is used, then have the coolant replaced by a specialist garage - there is a risk of engine damage. ■ A loss of coolant could be due to leaks in the cooling system - there is a risk of engine damage. Switch off the engine and seek assistance from a specialist Read and observe and on page ėĝĖ first. garage. Check the coolant under the following conditions and refill. Note  0he vehicle is on a horizontal surface. A coolant level which is too low is indicated in the instrument cluster by the  0he engine is not warm (if the engine is warm, the test results could bewarning light  and shown by the relevant message » page ĘĞ. 3e still rec- inaccurate). ommend inspecting the coolant level directly at the reservoir from time to time.  0he engine is turned off. Check the coolant level - the coolant level must be between the marks A and Brake fluid B » Fig. ĘĘĘ. If the coolant level is below the mark B , refill the coolant. Refilling Fig. ĘĘę 0he coolant expansion tank must always contain a small amount of coolant Brake fluid reservoir » . ›Place a cloth over the cap of the coolant expansion tank and unscrew the cap carefully. ›Always top up using the correct specification of fluids. ›0urn the cap until it clicks into place. 0he specification of the coolant is shown on the coolant expansion reser- voir» Fig. ĘĘĘ. Check the brake fluid under the following conditions. If no specified coolant is available, use only distilled or demineralised water  0he vehicle is on a horizontal surface. and have the mixing ratio of water and coolant additive corrected by a special-  0he engine is turned off. ist garage as soon as possible. Check brake fluid level - the brake fluid level must be between the markings  “MIN” and “MA4”» Fig. ĘĘę. ėĝė General Maintenance

All pages in one PDF file!

How to get the code?
It's very simple! Just pay through a secure PayPal payment.
It will take no longer than a few minutes.
You will receive the code immediately after payment.
The code will be displayed on the screen and will be sent to you by e-mail address.

---

:

How many PDF files you want to download:
1 PDF file $4,00 USD 3 PDF files $8,00 USD 5 PDF files $12,00 USD

- I agree to the terms of service

Site map |
Privacy |
DMCA |
Terms of service
contact e-mail: contact @ man4car.com
All marks are the property of their respective holders