owners manual Seat Exeo

all ratings: 0 average rating: 5

exeo_EN.book Seite 275 Montag, 30. August 2010 4:45 16 If and when 275 Remove the bulb holder Changing bulbs When changing a bulb, you must first remove the bulb holder.All bulbs can be changed easily in the bulb holder. Fig. 213 Position of the bulbs in the bulb holder. Fig. 212 Retaining tabs Example: Left tail light in on reverse side of tail light side panel There are three securing tabs on the inside of the tail light.The bulbs are secured with a bayonet fastener. The table below gives an overview of the bulb positions. A – Release the retaining tabs ⇒fig.212 . A – Take out the bulb holder. – Lightly press the defective bulb into the bulb holder, then turn it to the left and remove it. – Change the defective bulb ⇒ page275 ⇒page276. – Fit the new bulb, pressing it into the bulb holder and turn it to the right as far as it will go. WARNING – Use a cloth to remove any fingerprints from the glass part of the If a bulb is replaced in a tail light assembly with LED, do not pull too hard bulb. on the bulb holder to avoid damaging the wiring of the LED module.– Check whether the new bulb is working. – Re-install the bulb holder ⇒ page 276. Safety First Operating Instructions Practical Tips Technical Specifications

All pages in one PDF file!

How to get the code?
It's very simple! Just pay through a secure PayPal payment.
It will take no longer than a few minutes.
You will receive the code immediately after payment.
The code will be displayed on the screen and will be sent to you by e-mail address.

---

:

How many PDF files you want to download:
1 PDF file $4,00 USD 3 PDF files $8,00 USD 5 PDF files $12,00 USD

- I agree to the terms of service

Site map |
Privacy |
DMCA |
Terms of service
contact e-mail: contact @ man4car.com
All marks are the property of their respective holders