owners manual Seat Exeo

all ratings: 0 average rating: 5

exeo_EN.book Seite 272 Montag, 30. August 2010 4:45 16 272 If and when Changing the side light bulb – Switch off the ignition and the lights. The procedure for changing the bulb is the same on both – Raise the bonnet. sides. – Move the brace ⇒fig.206 1 in the direction of the arrow and A remove the rigid cover, separating the brace side and then removing the two tabs from the other end of the cover. – Remove the bulb holder by pulling on the grip ⇒ fig. 207 (it can also be removed by pulling on the bulb holder wires). – Separate the bulb from the bulb holder by pulling both pieces anti-clockwise. – Fit the new bulb by pressing on the bulb holder. – Insert the bulb into the socket and press on the bulb holder grip. Fig. 206 Side light– Fit the cover, first inserting the side tabs and then closing the cover and the brace. Make sure that the gasket sits well on the casing cover during the operation. – Check whether the new bulb is working. Changing the xenon bulb The procedure for changing the bulb is the same on both sides. WARNING This type of bulb should be changed at a qualified workshop. Fig. 207 Side light

All pages in one PDF file!

How to get the code?
It's very simple! Just pay through a secure PayPal payment.
It will take no longer than a few minutes.
You will receive the code immediately after payment.
The code will be displayed on the screen and will be sent to you by e-mail address.

---

:

How many PDF files you want to download:
1 PDF file $4,00 USD 3 PDF files $8,00 USD 5 PDF files $12,00 USD

- I agree to the terms of service

Site map |
Privacy |
DMCA |
Terms of service
contact e-mail: contact @ man4car.com
All marks are the property of their respective holders