owners manual Seat Exeo

all ratings: 0 average rating: 5

exeo_EN.book Seite 271 Montag, 30. August 2010 4:45 16 If and when271 Changing the turn signal bulb – Switch off the ignition and the lights. The procedure for changing the bulb is the same on both – Raise the bonnet. sides. – Pull the rubber cap ⇒ fig. 204 to remove it. – Remove the bulb holder by pulling on the grip and turning it anti- clockwise ⇒fig.205. – Replace the blown bulb in the bulb holder (press and turn anti- clockwise to remove) with a new bulb (press and turn clockwise to insert). – Insert the bulb holder into the socket with the tab facing upwards and the grip horizontal. Press it against the socket and turn clockwise. When changing the bulb, you can check the position of the bulb through the headlight glass. Fig. 204 Turn signal– Fit the rubber cap and tighten, making sure it fit properly into the headlight casing. – Check whether the new bulb is working. Fig. 205 Turn signal Safety First Operating Instructions Practical Tips Technical Specifications

All pages in one PDF file!

How to get the code?
It's very simple! Just pay through a secure PayPal payment.
It will take no longer than a few minutes.
You will receive the code immediately after payment.
The code will be displayed on the screen and will be sent to you by e-mail address.

---

:

How many PDF files you want to download:
1 PDF file $4,00 USD 3 PDF files $8,00 USD 5 PDF files $12,00 USD

- I agree to the terms of service

Site map |
Privacy |
DMCA |
Terms of service
contact e-mail: contact @ man4car.com
All marks are the property of their respective holders