Mitsubishi Eclipse II technical information manual page 262

text version of content this owner's manual page from owners manual to the vehicle Mitsubishi Eclipse, year of production 1995 - 1999:

DRIVE-CONTROL COMPONENTS - ABS 3-41 NOTE *l: The ABS-ECU can detect only an open circuit from the moment the ECU power supply is ON. LJ The ABS-ECU lights the ABS warning light when it detects an open circuit, but it does not immediately store the trouble code in memory and does not cause the system to shut down. When an open circuit is detected, the trouble code is stored in memory and the system caused to shut down when the vehicle starts and the wheel speed reaches 6 km/h (4 mph) (the first acceleration after theIG has been placed in the ON state). Troubles other than an open circuit cannot be detected until the wheel speed reaches 6 km/h (4 mph). When the ABS-ECU detects any of these troubles, it causes the system to shut down and simultaneously lights the ABS warning light. When the ABS ECU detects a wheel speed sensor error during ABS control, it causes the system to shut down and simultaneously lights the ABS warning light. *2: The ABS-ECU detects a power supply error when the supplied voltage is a low voltage (approx.9V or less). When the power supply error is detected, it causes the system to shut down and simultaneously lights the ABS warning light, but does not store the trouble code in memory. The trouble code is stored in memory when the voltage returns to normal. When the power voltage is low (approx.9V or less), none of the trouble codes is stored in memory. *3: The ABS-ECU takes more than 15 minutes from when it detects an error to when it determines that the fault has occurred. *4: The ABS-ECU makes an initial check on the motor relay and motor when the wheel speed reaches 6 km/h (4 mph) for the first time after engine start. If anything wrong is detected, it causes the system to shut down and simultaneously lights the ABS warning light. tic troublecodes and goes back to the normal (1) The codes for the currently present or previously occurred failures are displayed. Each code is control mode. Thereafter, if the ABS system is in order, the ABS control is available. If the displayed once. After all the codes in store have system is out of order, the warning light illumi- been displayed, they are repeatedly displayed, L beginning with the first one. nates and the brake system is placed in the (2) If the vehicle is put in motion and any of the ordinary braking mode. No more codes will be output until the ignition key is placed in the ON wheels reaches a speed of more thanIO km/h (6 mph) during display of diagnostic troubleposition again. codes, the system stops displaying thediagnos- 2. Diagnostic Trouble Code Indication Method Diagnostic trouble codes are indicated as described below, depending on failure conditions in the system. Display on scan toolDisplay by ABS warning light I System failure condition I No diagnostic trouble code displayed.ON/OFF at 0.5 sec. intervals No failure detected in the past (no-failure code) All codes associated with the failures detected in the pastAll codes associated with the failures that occurred in the past are displayed,that occurred in the past are displayed, beginning with the most recent one. beginning with the most recent one. NOTE Even if failures of a same code repeatedly occur, the code that is displayed is the one stored for the first time only.

owners manual Mitsubishi Eclipse

owners manual Mitsubishi Eclipse - year of production: 1995, 1996, 1997, 1998, 1999 - Mitsubishi Eclipse II technical information manual EN