owners manual Seat Ateca

all ratings: 0 average rating: 5

Operation Unlock the tow hitch and remove itMeaning of control lamp ● If the ball has a diameter of less than 49 ● ● mm at any one point, do not use the towing Stop the vehicle and connect the electronicIf the warning light of the button ››› Fig. 217 bracket under any circumstances. parking brake ››› page 170.is flashing, this means that the tow hitch has not been attached properly or is damaged ●Switch off the engine. ››› . CAUTION ●Open the rear lid. ●If the warning lamp stays on with the rear If you clean the vehicle with high-pressure or ●Pull the ››› Fig. 217 button briefly. The tow lid open, the tow hitch is correctly in place s eam devices, do not point the jet directly t hitch unlocks electrically and automatically both when engaged and when covered.towards the retractable tow hitch or the trail- turns outwards. The control lamp in the but- er power socket, as this may damage the ●The control lamp of the button will go off ton will flash ››› Fig. 217. joints or remove the grease necessary for lu- approx. 1 minute after closing the rear lid. ●Remove the tow hitch with your hand until brication. you feel and see that it has engaged and the WARNING control lamp on the button stays on. Note Undue use of the towing bracket may cause ●Close the tailgate. injury and accidents. At extremely low temperatures, the tow hitch may be impossible to use. In this case, place ● Only use the tow hitch if it is properly en- Cover the tow hitch the vehicle in a warmer location (for example, gaged. a garage). ●Stop the vehicle and apply the electronic ● Always ensure that no person, animal or parking brake. object is to be found in the path of the tow ● hitch. Switch off the engine. Fitting a bicycle carrier on the retract- ● Never use a tool or instrument while the ●Unhook the trailer and interrupt the electri- le tow hitch tow hitch is moving. ab cal connection between it and the vehicle. If you are using an adapter, remove it from the● Never press the ››› Fig. 217 button when The maximum allowed weight of the carrier trailer's power socket. there is a trailer hooked to the vehicle or system, including the load, is 75 kg. The car- when a carrier system or other accessories ●Open the rear lid. rier system should not protrude more than are mounted on the tow hitch. ●Pull the ››› Fig. 217 button briefly. The tow 700 mm backwards from the spherical head. ● If the tow hitch is not attached properly, do hitch unlocks electrically. Only carrier systems on which up to 3 bikes not use it. Instead, go to a specialised work- can be mounted are allowed. Heavier bicy- ●Turn the tow hitch under the bumper withshop and have the towing bracket checked. cles must be mounted as close to the vehicle your hand until you feel and see that it en- ● If you detect any fault in the electrical sys- as possible (tow hitch). gages and the control lamp on the ››› Fig. 217 tem or in the towing bracket, contact a speci- button stays on. alised workshop and ask them to check it. ●Close the tailgate. 258

All pages in one PDF file!

How to get the code?
It's very simple! Just pay through a secure PayPal payment.
It will take no longer than a few minutes.
You will receive the code immediately after payment.
The code will be displayed on the screen and will be sent to you by e-mail address.

---

:

How many PDF files you want to download:
1 PDF file $4,00 USD 3 PDF files $8,00 USD 5 PDF files $12,00 USD

- I agree to the terms of service

Site map |
Privacy |
DMCA |
Terms of service
contact e-mail: contact @ man4car.com
All marks are the property of their respective holders