owners manual Seat Ateca

all ratings: 0 average rating: 5

Operation Technical requirements into account the speed limit for vehicles witheye should not be used for tow-starting or for trailers in the corresponding country, as ittowing other vehicles. For this reason, if the Vehicles that are factory-equipped with a could be less than the speed limit for vehi-vehicle has been retrofitted with a towing cles without a trailer. bracket, always keep the tow hitch in the ve-towing bracket fulfil all the technical and le- hicle when you disassemble it.gal requirements for driving with a trailer. ● Never attempt to “straighten” the towing vehicle and trailer while accelerating. If the vehicle is retrofitted with a towing bracket, only a bracket that is authorised for Control lamp the maximum authorised load of the trailer WARNING that is to be towed may be fitted. The towing If the towing bracket has been retrofitted by a bracket must be suitable for the vehicle and The tow hitch is not securely locked in non-SEAT workshop, the Start-Stop system  the trailer and must be properly secured to position. must be disconnected manually whenever the vehicle's chassis. Only use a towing driving with a trailer. Otherwise the brake Check that the towing bracket is locked ››› page 257. bracket that has been authorised by SEAT for system could be damaged and could conse- this vehicle. Always check and take into ac- quently cause a serious accident or injury. Some warning and control lamps will light up count the towing bracket manufacturer's in- ● Always disconnect the Start-Stop system when the ignition i briefly s switched on to structions. Never fit a towing bracket “with manually when using a towing bracket that check certain functions. They will switch off weight distribution” or “load compensation”. has not been fitted by a SEAT workshop. after a few seconds. Towing bracket fitted on the bumper Note WARNING Never fit a towing bracket to the bumper or to ● Before hitching or unhitching a trailer, al- If the warning lamps and the corresponding the area where the bumper is mounted. The ways deactivate the anti-theft alarmmessages are ignored when they light up, the towing bracket should not impair the bum- ››› page 112. Otherwise, the tilt sensor couldvehicle may stall in traffic and cause acci- per's function. Do not make modifications or cause the alarm to go off.dents and severe injuries. repairs to the exhaust system or the brake ● Do not drive with a trailer for the engine's● Never ignore the warning lamps or messag- system. Make regular checks to ensure that first 1000 km ››› page 184.es. the towing bracket is secure. ● SEAT recommends that, if possible, the tow● Stop the vehicle at the next opportunity hitch be disassembled or covered when it isand in a safe place. Engine cooling system not going to be used. In the event of a rear- end collision, the damage to the vehicle Driving with a trailer increases the load on CAUTION could be greater if the bracket is fitted. the engine and cooling system. The cooling Failure to heed the control lamps and corre-system should have sufficient coolant and be ● Some retrofitted towing brackets cover the sponding text messages when they light up prepared for the additional effort involved in rear towing eye. In these cases, the towing may result in damage to the vehicle. driving with a trailer. 256

All pages in one PDF file!

How to get the code?
It's very simple! Just pay through a secure PayPal payment.
It will take no longer than a few minutes.
You will receive the code immediately after payment.
The code will be displayed on the screen and will be sent to you by e-mail address.

---

:

How many PDF files you want to download:
1 PDF file $4,00 USD 3 PDF files $8,00 USD 5 PDF files $12,00 USD

- I agree to the terms of service

Site map |
Privacy |
DMCA |
Terms of service
contact e-mail: contact @ man4car.com
All marks are the property of their respective holders