Mitsubishi Outlander PHEV III 3 owners manual page 226

text version of content this owner's manual page from owners manual to the vehicle Mitsubishi Outlander PHEV, year of production 2012:

B０0203201E３.book 63 ページ㸰㸮㸯㸱年㸯㸯月㸯９日　火曜日　午前㸯㸯時５㸮分 Reversing sensor system* CAUTION CAUTION CAUTION •When passing a road section where the •When the windscreen is covered with rain zThe reversing sensor system assists you in number of lanes increases/decreases or water, snow, dust, etc. determining the approximate distance multiple lanes are crossing each other. zFollow the instructions given below to keep between the vehicle and an obstacle located •When the lane is marked by double or oth- your LDW in good operating conditions. behind the vehicle. It has limitations in terms erwise special lines. •Always keep the windscreen clean. of detectable areas and objects, and may not •When driving on a winding or rough road. •Avoid applying a strong shock or pressure properly detect some objects. Therefore, do •When driving on a slippery road covered by to the LDW camera. Do not attempt to dis- not place excessive confidence in the revers- rain water, snow, ice, etc. assemble it. ing sensor system, and operate the vehicle as •When passing through a place where the •Disturbing the installation of the LDW carefully as you would a vehicle without this brightness suddenly canges,h like the inlet camera or its removal is under no circum- system. or outlet of a tunnel. stances permitted. The camera has been zMake sure to check the surroundings with 7 •When turning steep curves. precisely oriented at the factory. your own eyes to ensure safety. Do not oper- •When the road surface is reflecting the light • Do not put anything like a sticker on the ate the vehicle by relying on the reversing shining from the direction opposite to the area in front of the LDW camera lens of the sensor system alone. running direction. windscreen. •Vehicle largely lurches when it is running •Use only MITSUBISHI MOTORS GENU- Obstacle detection areas over steps or other irregularities of the road INE Parts when replacing the windscreen surface. wipers. E00615601473 •When the headlamp illumination is inade- The detection areas of the corner and back quate because of contaminated or deterio- Reversing sensor system* sensors are limited to those shown in the rated lenses or improperly aimed illustration. Moreover, the sensors are unable headlamps. E00615500374to detect low or thin objects or objects near •When the vehicle is leaning much to one This system operates when you are backing the rear bumper. Thus, make sure to check the side due to heavy uggage lon it or improp- the vehicle. It uses corner and back sensors to surroundings as you operate the vehicle in a erly adjusted tyre pressures. detect an obstacle and the information screen safe manner. •When oncoming vehicles’ headlamps shine in the multi information display and the the LDW camera. buzzer to inform you of the approximate dis- •When the vehicle is equipped with non- tance to the obstacle. Corner and back sensor locations standard tyres (incuding lexcessively worn tyres), uses snow traction device (tyre There are two corner sensors (A) at the cor- chains), or has non-specified components ners of the rear bumper, and two back sensors such as a modified suspension. (B) in the centre of the rear bumper. Starting and driving 7-63

owners manual Mitsubishi Outlander PHEV

owners manual Mitsubishi Outlander PHEV - year of production: 2012 - Mitsubishi Outlander PHEV III 3 owners manual EN