owners manual Skoda Octavia

all ratings: 0 average rating: 5

0he valve remover Ė has a slot at its lower end which fits into the valve core. Note 0his is the only way in which you can remove and re-install the valve core from the tyre valve. 0he same also applies to the replacement valve core ĖĖ . Immediately replace the wheel that was repaired using the breakdown kit or con-  sult a ŠKODA specialist garage about repair possibilities. Note ■ Observe the manufacturer's usage instructions for the breakdown kit. Breakdown kit ■  A new bottle of sealant can be purchased from ŠKODA Original Parts. Preparations for the use of the breakdown kit First read and observe the introductory information and safety warn- ings on page ėĖĞ.  0he following preparatory work must be carried out before using the breakdown kit. ›Park the vehicle as far away as possible from the flow of traffic. Park on as flat and firm a surface as possible. ›If you are in flowing traffic, switch on the hazard warning light system and set up the warning triangle at the prescribed distance! 0he national legal require- ments must be observed. ›Let all of the occupants get out. 3hile changing a tyre, the occupants of the Fig. ĖĞę Components of the breakdown kit vehicle should not stand on the road (instead they should remain behind a crash First read and observe the introductory information and safety warn-barrier). ings on page ėĖĞ. ›Switch off the engine and move the gearshift lever into Neutral or move the se-  lector lever on the automatic gearbox into position P. 0he kit is located in a box under the floor covering in the luggage compartment.Firmly apply the handbrake. › ›Check that you can carry out the repairs with the breakdown kit » page ėĖĞ. Components of the breakdown kit ›If a trailer is connected, remove it. Ė 2alve remover ›Remove the breakdown kit from the luggage compartment. ė Sticker with speed designation “max. ĝĕ km/h” ›Stick the sticker ė » Fig. ĖĞę on page ėėĕ on the dash panel in view of the driv- er. Ę Inflation hose with plug ›1nscrew the valve cap. ę Air compressor ›1se the valve remover Ė to unscrew the valve core and place it on a clean sur- Ě 0yre inflation hose  face (rag, paper, etc.). ě 0yre inflation pressure indicator Ĝ Air release valve ĝ ON and OFF switch Ğ Ėė volt cable connector Ėĕ 0yre inflator bottle with sealing agent ĖĖ Replacement valve core ėėĕ Do-it-yourself

All pages in one PDF file!

How to get the code?
It's very simple! Just pay through a secure PayPal payment.
It will take no longer than a few minutes.
You will receive the code immediately after payment.
The code will be displayed on the screen and will be sent to you by e-mail address.

---

:

How many PDF files you want to download:
1 PDF file $4,00 USD 3 PDF files $8,00 USD 5 PDF files $12,00 USD

- I agree to the terms of service

Site map |
Privacy |
DMCA |
Terms of service
contact e-mail: contact @ man4car.com
All marks are the property of their respective holders