owners manual Skoda Octavia

all ratings: 0 average rating: 5

s43s.1.book Page 221 Thursday, May 13, 2010 1:21 PM Breakdown assistance 221 – Insert the adapter B with its toothed side fu lly into the inner toothing of the safety Both batteries must have a rated voltage of 12 V. The capacity (Ah) of the battery A wheel bolt A right down in such a way that only the outer hexagon is jutting out supplying the power must not be significantly less than the capacity of the discharged A page220, fig.180. battery in your vehicle. B – Insert the wheel wrench* fully onto the adapter A. Jump-start cables – Slacken the wheel bolt, or tighten it firmly  page 219. Only use jump-start cables which have an adequately large cross-section and insu- – Reinstall the full wheel trim/wheel cap after removing the adapter or place the cap lated terminal clamps. Please pay attention to the manufacturer's instructions. onto the safety wheel bolt. Positive cable - colour coding in the majority of cases red. – Have the tightening torque checked with a torque wrench as soon as possible. Negative cable - colour coding in the majority of cases black. Steel and light alloy wheels must be tightened to a tightening torque of 120 Nm. The safety wheel bolts on vehicles fitted with them (one safety wheel bolt per wheel) WARNING can only be loosened or tighten up by using the adapter provided.  A discharged battery may already freeze at temperatures just below 0°C. In It is meaningful to note the code number hammered into the rear side of the adapter case of frozen battery carry out no jump-starting - risk of explosion! or the rear side of the safety wheel bolts. You can obtain a replacement adapter from  Please pay attention to the warning instructions relating to working in the an authorised Škoda Service Partner, if necessary, by quoting this number.engine compartment page197, “Working in the engine compartment”. We recommend that you always carry the adapter for the wheel bolts with you in the vehicle. It should be stowed in the vehicle tool kit. Note  There must not be any contact between the two vehicles otherwise current may Caution flow as soon as the negative terminals are connected. Damage can occur to the adapter and safety wh eel bolt if the safety wheel bolt is tight- The discharged battery must be properly connected to the system of the vehicle. ened up too much.  Switch off any mobile phone, pay attention to the instructions for use of the mobile phone in such a situation. Note  We recommend that you purchase the jump-starting cable in the specialist shops The set of safety wheel bolts can be obtained from an authorised Škoda Service of the battery manufacturers. Partner. Jump-starting Initial steps You can use the battery of another vehicle for jump-starting yours if the engine does not start because the battery on your vehicle is flat. You will require jump-start cables for this purpose. Using the system Safety Driving Tips General Maintenance Breakdown assistance Technical Data

All pages in one PDF file!

How to get the code?
It's very simple! Just pay through a secure PayPal payment.
It will take no longer than a few minutes.
You will receive the code immediately after payment.
The code will be displayed on the screen and will be sent to you by e-mail address.

---

:

How many PDF files you want to download:
1 PDF file $4,00 USD 3 PDF files $8,00 USD 5 PDF files $12,00 USD

- I agree to the terms of service

Site map |
Privacy |
DMCA |
Terms of service
contact e-mail: contact @ man4car.com
All marks are the property of their respective holders