owners manual Skoda Octavia

all ratings: 0 average rating: 5

s43s.1.book Page 218 Thursday, May 13, 2010 1:21 PM 218 Breakdown assistance Changing a wheel – Have the tightening torque of the wheel bolts checked with a torque wrench as soon as possible. Steel and light alloy wheels must be tightened to a tightening Always change a wheel on a level surface as far as possible.torque of 120 Nm. – Take off the full wheel trim*  page218 or the caps page219.– Change the damaged wheel or consult a specialist garage about possibilities for – In the case of light alloy wheels remove the wheel trim cap  page 219.getting repairs done. – First of all slacken the safety wheel bolt * and afterwards the other wheel bolts WARNING page219. – Jack up the vehicle until the wheel to be changed is clear of the ground It is necessary to observe the guidelines given on page210 if the vehicle is page220. subsequently fitted with tyres which are different to those it was fitted with at the works. – Unscrew the wheel bolts and place them on a clean surface (cloth, paper etc.). – Take off the wheel. Note – Fit on the spare wheel and tighten the wheel bolts slightly. If you find, when changing the wheel, that the wheel bolts are corroded and diffi- –Lower the car. cult to turn, the bolts must be replaced before checking the tightening torque. – Tighten the wheel bolts firmly, alternately and diagonally using the wheel wrench  Drive cautiously and only at a moderate speed to a workshop where the tightening (crosswise) and last the safety wheel bolt*  page 219.torque can be checked. – Mount the full wheel trim/wheel trim cap or the caps.Full wheel trim* Note Pulling off  All bolts must be clean and must turn easily.– Hook the clamp found in the vehicle tool kit into the reinforced edge of the full  You must never grease or oil the wheel bolts! wheel trim.  When fitting on unidirectional tyres, ensure that the tyres rotate in the correct – Push the wheel wrench* through the clamp, support the wheel wrench at the tyre direction page208. and pull off the wheel trim. Subsequent steps Installing – First press the full wheel trim onto the wheel at the valve opening provided. Then After changing the wheel, you must perform the following steps.press the full wheel trim into the wheel in such a way that its entire circumference – Stow and attach the replaced wheel in the spare wheel well.locks correctly in place. – Stow the vehicle tool kit in the space provided. – Check the tyre pressure on the spare wheel just mounted as soon as possible.

All pages in one PDF file!

How to get the code?
It's very simple! Just pay through a secure PayPal payment.
It will take no longer than a few minutes.
You will receive the code immediately after payment.
The code will be displayed on the screen and will be sent to you by e-mail address.

---

:

How many PDF files you want to download:
1 PDF file $4,00 USD 3 PDF files $8,00 USD 5 PDF files $12,00 USD

- I agree to the terms of service

Site map |
Privacy |
DMCA |
Terms of service
contact e-mail: contact @ man4car.com
All marks are the property of their respective holders