owners manual Skoda Octavia

all ratings: 0 average rating: 5

s43s.1.book Page 220 Thursday, May 13, 2010 1:21 PM 220 Breakdown assistance – Align the lifting jack* so that its claw grasps the web of the lower sill A and the Tightening wheel bolts A base plate B is resting flat on the floor. – Push the wheel wrench* fully onto the wheel bolt 19).A – Grasp the end of the wrench* and turn the bolt to the right until it is tight.– Turn the lifting jack* up further until the wheel is just clear of the ground. Ground which is soft and slippery below the lifting jack* can cause the vehicle to slip WARNING off the lifting jack*. It is therefore always necessary to place the lifting jack* on a solid Slacken the wheel bolts only a little (about one turn) as long as the vehicle has surface or use a wide and stable base. Use a non-slip base (e.g. a rubber foot mat) if not yet been lifted with the lifting jack* - risk of accident!the surface is smooth, such as cobbled stones, a tiled floor, etc. Note WARNING Apply pressure carefully with your foot to the end of the wrench* if it proves difficult  Always raise the vehicle with the doors closed - risk of injury! to slacken the bolts. Hold tight on the vehicl e when doing this and ensure that you have  Take suitable measures to prevent the base of the lifting jack from slipping a steady position. off - risk of injury!  Not positioning the lifting jack* at the specified points can result in damage Raise vehicle to the vehicle. The jack can al so slip off if it does not have sufficient grip - risk of You have to raise the vehicle with the lifting jack* in order to be able to injury! take off the wheel.  It is important to support the vehicle with suitable supporting blocks if you wish to work under the lifted vehicle - risk of injury! Securing wheels against being stolen* You need a special adapter for slackening the safety wheel bolts. Fig. 179 Changing a wheel: Jacking points for positioning lifting jack Position the lifting jack* by selecting the jacking point which is closest to the wheel to be removed fig.179. The jacking point is located directly below the engraving in the lower sill. The engraving is only visible after opening the door. Fig. 180 Safety wheel bolt with adapter – Position the lifting jack* below the jacking point and move it up until its claw is positioned directly below the vertical web of the lower sill.– Pull off the full wheel trim/cap from the wheel hub or cap from the safety wheel bolt.

All pages in one PDF file!

How to get the code?
It's very simple! Just pay through a secure PayPal payment.
It will take no longer than a few minutes.
You will receive the code immediately after payment.
The code will be displayed on the screen and will be sent to you by e-mail address.

---

:

How many PDF files you want to download:
1 PDF file $4,00 USD 3 PDF files $8,00 USD 5 PDF files $12,00 USD

- I agree to the terms of service

Site map |
Privacy |
DMCA |
Terms of service
contact e-mail: contact @ man4car.com
All marks are the property of their respective holders