or
owners manual Alfa Romeo 33
owners manual Alfa Romeo 33 - year of production: 1983, 1984, 1985, 1986, 1987, 1988, 1989, 1990, 1991, 1992, 1993, 1994, 1995 - Alfa Romeo 33 owners manual EN
Document:
pdf (12.9 MB) 378 pages
all ratings: 0
average rating: 5
text version of content this owner's manual page
from owners manual to the vehicle Alfa Romeo 33, year of production 1983 - 1995:
COMPLETE CAR
1 Bolt 3 Screw
2 Bolt
Replacing timing belts with
engine on car
6. Interpose tool C.6.0168 between
1 Mark on rear cover
tapper bucket upper part and cam
REMOVAL 2 T - shaped reference mark
minimum radius and, by means of
wrench A.5.0193, operate until the
1. Disconnect electric fan wiring,
6. Loosen
idlerpulleyslock
prescribed clearance is obtained.
. loosen relevant screws
0 and nuts 1 and then press idler
7. For better security check clear- 0
remove fan from radiator through
ance after having removed previously pulleys @ so as to overcome
lower channel0. tension load on belts. Tighten
inserted cup locking pin. nuts while in this position.
0
8. Repeat the procedure for each
valve of the two heads.
9. At the end of operation, restore
the tank oil level and reassemble
cover and spark plugs.
CHECKING, REPLACING
AND ADJUSTING DRIVE
BELTS
Alternator and water pump
control belt
Inspect belt for cracks or damage.
2
w
Replace it if necessary. Push on belt 1 Locknur
1 Screw 2 Channel 2 Idler pulley
longest section, located between
engine pulley and alternator pulley,
7. Now remote first the right hand
applying an 79 N (8 kg; 3.63 lb) load
cogged belt and then the left hand
2. Remove spark plugs, alternator
and verify relevant deflection which
belt from camshaft andcrakshaft
and water pump control belt.
should be of 15 mm (0.59 in);
pulleys.
3. Remove camshaft belts plastic
contrarywise proceed to adjust belt
tension as follows. covers.
4. Remove camshaft support cov-
ASSEMBLY
7. Loosen bolts ers.
1 and0 as
5. Remove timing plastic cover
well as screws CAUTION:
3 that secure
8 located on cylinder block rear cover,
alternator support bracket to the Check again engine timing proceed-
and rotate crankshaft till piston in
engine’s front cover. ing as per step Sabove.
no. 1 cylinder is set in top dead
2. Move the alternator so as to
center on its combustion -stroke.
either stretch or slacken the belt and
Such correct position is achieved
then tighter&gain bolt0. 1. Rotate camshafts till reference
when thT-shapede referencemarks stamped on same are in line
3. Check again belt tension and
mark @ on flywheel is in line with
with those stamped on relevant
then tighten all previously loosened
the mark on rear cover 1
bolts. 0. support.
00-25 May 1983
Download PDF
Click here to download a pdf file with an instruction manual for Alfa Romeo 33
year of production from: 1983
Do you prefer pdf format?
Find out how to download
Enter the code to download PDF file:
All pages in one PDF file!
How to get the code?
It's very simple! Just pay through a secure PayPal payment.
It will take no longer than a few minutes.
You will receive the code immediately after payment.
The code will be displayed on the screen and will be sent to you by e-mail address.
:
Alfa Romeo 33 owners manual
pages 19 - 25
Alfa Romeo 33 owners manual
page 22 / 378
this site is maintained by advertising - for view instructions, turn off ad blocking in your browser
Download PDF
Others owner's manuals for this model: