owners manual Mercedes E

all ratings: 0 average rating: 5

212_AKB; 2; 41, en-US 2009-07-17T09:14:21+02:00 - Seite 215 d2ureepe, Version: 2.11.8.1 Useful features 215 Reprogramming a single signal Programming tips transmitter button If you are having difficulty programming the To program a device using a signal integrated remote control, here are some transmitter button previously trained, followhelpful tips: these steps: R Check the frequency of hand-held remote XSwitch on the ignition. control A (typically located on the reverse XPress and hold the desired signal side of the remote). The integrated remote transmitter button (;, = or ?). Do notcontrol is compatible with radio-frequency devices operating between 280-390 MHz. release the button. Indicator lamp : will begin to flash after R Put a new battery in hand-held remote 20 seconds. control A. This will increase the likelihood XWithout releasing the signal transmitter of the hand-held remote control sending a button, proceed with programming starting stronger and more accurate signal to the with step 3. integrated remote control. R While performing step 3, hold hand-heldControls in detail Operation of integrated remote control remote control A at different lengths and angles from the signal transmitter button XSwitch on the ignition. (;, = or ?) you are programming. XSelect and press the appropriate Attempt varying angles at the distance of 2 integrated signal transmitter button (;, to 12 inches (5 to 30 cm) away or the same = or ?) to activate the remote controlled angle at varying distances. device. R If another hand-held remote control is The integrated remote control transmitter available for the same device, try the continues to send the signal as long as the programming steps again using that other button is pressed – up to 20 seconds. hand-held remote control. Make sure new batteries are in the hand-held remote Erasing the integrated remote control control before beginning the procedure. memory R Straighten the antenna wire from the iIf you sell your vehicle, erase the codes of garage door opener assembly. This may all three channels. help improve transmitting and/or receiving signals. XSwitch on the ignition. XSimultaneously press and hold outer signal iCertain types of garage door openers are transmitter buttons ; and ?, for incompatible with the integrated remote approximately 20 seconds, until indicatorcontrol. If you should experience further lamp : flashes rapidly. Do not hold fordifficulties with programming the longer than 30 seconds. integrated remote control, contact an The codes of all three channels are erased.authorized Mercedes-Benz Center, or call the Mercedes-Benz Customer Assistance Center (USA only) at 1-800-FOR-MERCedes (1-800-367-6372), ® or the HomeLink Hotline (USA only) at 1-800-355-3515, or the Customer Service (Canada only) at 1-800-387-0100. Z

All pages in one PDF file!

How to get the code?
It's very simple! Just pay through a secure PayPal payment.
It will take no longer than a few minutes.
You will receive the code immediately after payment.
The code will be displayed on the screen and will be sent to you by e-mail address.

---

:

How many PDF files you want to download:
1 PDF file $4,00 USD 3 PDF files $8,00 USD 5 PDF files $12,00 USD

- I agree to the terms of service

Site map |
Privacy |
DMCA |
Terms of service
contact e-mail: contact @ man4car.com
All marks are the property of their respective holders