owners manual Mercedes E

all ratings: 0 average rating: 5

212_AKB; 2; 41, en-US 2009-07-17T09:14:21+02:00 - Seite 213 d2ureepe, Version: 2.11.8.1 Useful features 213 transmitter buttons, do not repeat this step When programming a garage door opener, and begin directly with step 3. park vehicle outside the garage. XStep 3: Hold the end of hand-held remote Do not run the engine while programming the control A of the device you wish to train integrated remote control. Inhalation of exhaust gas is hazardous to your health. Allapproximately 2 to 12 in (5 to 30 cm) away exhaust gas contains carbon monoxide (CO),from the signal transmitter button (;, = and inhaling it can cause unconsciousnessor ?) to be programmed, while keeping and possible death. indicator lamp : in view. XStep 4: Using both hands, simultaneously press hand-held remote control button B and the desired signal transmitter button (;, = or ?). Do not release the buttons until step 5 is completed. Indicator lamp : will flash, first slowly and then rapidly. Controls in detail iIndicator lamp : flashes immediately the first time the signal transmitter button is programmed. If this button has already been programmed, the indicator lamp will Interior rear view mirror with integrated remote start flashing after 20 seconds. control XStep 5: After indicator lamp : changes Hand-held remote control A is not part of the from a slow to a rapidly flashing light, vehicle equipment. release the hand-held remote control button and the signal transmitter button. Programming the integrated remote XStep 6: Press and hold the just-trained control signal transmitter button (;, = or ?) and XStep 1: Switch on the ignition. observe indicator lamp :. XStep 2: If you have previously programmed If indicator lamp : stays on constantly, a signal transmitter button and wish to programming is complete and your device retain its programming, proceed to step 3. should activate when the respective signal or transmitter button (;, = or ?) is pressed XIf you are programming the integrated and released. remote control for the first time, press and iIf indicator lamp : flashes rapidly for hold the two outer signal transmitter approximately 2 seconds and then turns to buttons ; and ? and release them when a constant light, continue with indicator lamp : begins to flash after programming steps 8 through 12 as your approximately 20 seconds. garage door opener may be equipped with Do not hold the buttons for longer than the “rolling code” feature. 30 seconds. XStep 7: To program the remaining two This procedure erases any previous signal transmitter buttons, repeat the steps settings for all three channels and above starting with step 3. initializes the memory. If you later wish to program a second and/or third hand-held transmitter to the remaining two signal Z

All pages in one PDF file!

How to get the code?
It's very simple! Just pay through a secure PayPal payment.
It will take no longer than a few minutes.
You will receive the code immediately after payment.
The code will be displayed on the screen and will be sent to you by e-mail address.

---

:

How many PDF files you want to download:
1 PDF file $4,00 USD 3 PDF files $8,00 USD 5 PDF files $12,00 USD

- I agree to the terms of service

Site map |
Privacy |
DMCA |
Terms of service
contact e-mail: contact @ man4car.com
All marks are the property of their respective holders