owners manual Mercedes E

all ratings: 0 average rating: 5

212_AKB; 2; 41, en-US 2009-07-17T09:14:21+02:00 - Seite 214 d2ureepe, Version: 2.11.8.1 214 Useful features Rolling code programming Gate operator/Canadian programming To train a garage door opener (or other rollingCanadian radio-frequency laws require code devices) with the rolling code feature,transmitter signals to “time-out” (or quit) follow these instructions after completing theafter several seconds of transmission which “Programming” portion (steps 1 through 6) ofmay not be long enough for the integrated this text. For your convenience and tosignal transmitter to pick up the signal during complete the procedure faster, you mightprogramming. Similar to this Canadian law, want to have someone assist you. some U.S. gate operators are designed to “time-out” in the same manner. XStep 8: Locate the “training” button on the If you live in Canada or if you are having garage door opener motor head unit. difficulties programming a gate operator iExact location and color of the button may (regardless of where you live) by using the vary by garage door opener brand. programming procedures, replace step 4 with Depending on manufacturer, the “training” the following: button may also be referred to as “learn” or XStep 4: Press and hold the signal “smart” button. If there is difficulty locating Controls in detail transmitter button (;, = or ?). Do not the transmitting button, refer to the garage release this button until it has been door opener Operator’s Manual. successfully trained. XStep 9: Press the “training” button on the XWhile still holding down the signal garage door opener motor head unit. transmitter button (;, = or ?), “cycle” The “training light” is activated. your hand-held remote control button B You have 30 seconds to initiate the as follows: Press and hold button B for following two steps. 2 seconds, then release it for 2 seconds, XStep 10: Return to the vehicle and firmly and again press and hold it for 2 seconds. press, hold for 2 seconds and release the Repeat this sequence on the hand-held programmed signal transmitter button (;, remote control until the frequency signal = or ?). has been learned. X Upon successful training, indicator Step 11: Press, hold for 2 seconds and lamp : will flash slowly and then rapidly release same signal transmitter button a second time to complete the trainingafter several seconds. process. X Proceed with programming step 5 and step 6 to complete. iSome garage door openers (or other rolling code equipped devices) may requirei Upon completion of programming the you to press, hold for 2 seconds and integrated remote control, make sure you release the same signal transmitter button retain the hand-held remote control that a third time to complete the training came with the garage door opener, gate process. operator or other device. You may need it for use in other vehicles, for future XStep 12: Confirm the garage door programming of an integrated remote operation by pressing the programmed control, or simply for continued use as a signal transmitter button (;, = or ?). hand-held remote control to operate the XStep 13: To program the remaining two respective device in other situations. signal transmitter buttons, repeat the steps above starting with step 3.

All pages in one PDF file!

How to get the code?
It's very simple! Just pay through a secure PayPal payment.
It will take no longer than a few minutes.
You will receive the code immediately after payment.
The code will be displayed on the screen and will be sent to you by e-mail address.

---

:

How many PDF files you want to download:
1 PDF file $4,00 USD 3 PDF files $8,00 USD 5 PDF files $12,00 USD

- I agree to the terms of service

Site map |
Privacy |
DMCA |
Terms of service
contact e-mail: contact @ man4car.com
All marks are the property of their respective holders