Nissan Cube owners manual page 216

text version of content this owner's manual page from owners manual to the vehicle Nissan Cube, year of production 2008:

Black plate (220,1) N(Neutral): Accelerator downshift Neither forward nor reverse gear is engaged. —In D position — The engine can be started in this position. You For passing or hill climbing, fully depress the may shift to N (Neutral) and restart a stalled accelerator pedal to the floor. This shifts the engine while the vehicle is moving. transmission down into a lower gear, depending on the vehicle speed. D(Drive): Use this position for all normal forward driving. High fluid temperature protection mode This transmission has a high fluid temperature L (Low): protection mode. If the fluid temperature be- Usethis position for maximum engine braking on comes too high (for example, when climbing steep downhill gradients/climbing steep slopes steep grades in high temperature with heavy and whenever approaching sharp bends. Do not loads), engine power and, under some condi- use the L (Low) position in any other circum- tions, vehicle speed will be decreased auto- SSD0863matically to reduce the chance of transmission stances. damage. Vehicle speed can be controlled with Overdrive (O/D) OFF switch (if sothe accelerator pedal, but the engine and vehicle equipped) speed may be limited. When the O/D OFF switch is pushed with the selector lever in the D (Drive) position, theFail-safe indicator light in the instrument panel illuminates.If the vehicle is driven under extreme Use the overdrive off mode when you needconditions, such as excessive wheel spin- improved engine braking. ning and subsequent hard braking, the fail-safe system may be activated. The MIL To turn off the overdrive off mode, push the O/Dmay illuminate to indicate the fail-safe OFF switch again. Theindicator light willmode is activated. (See “Malfunction In- turn off. dicator Light (MIL)” in the “2. Instruments Each time the engine is started, or when theandcontrols” section.) This will occur even selector lever is shifted to any position otherifall electrical circuits are functioning than the D (Drive) position, the overdrive offproperly. In this case, place the ignition mode will be automatically turned off.switch in the OFF position and wait for 10 seconds. Then turn the switch back to the 5-16 Starting and driving Model "Z12-D" EDITED: 2009/ 9/ 17

owners manual Nissan Cube

owners manual Nissan Cube - year of production: 2008 - Nissan Cube owners manual EN