Nissan Cube owners manual page 213

text version of content this owner's manual page from owners manual to the vehicle Nissan Cube, year of production 2008:

Black plate (217,1) 3minutes before shutting it off. Starting andextremely cold weather or when restart-4.Warm-up stopping the engine over a short period ofing, depress the accelerator pedal a littleAllow the engine to idle for at least 30 time may make the vehicle more difficult to(approximately 1/3 to the floor) andseconds after starting. Do not race the start. while holding, crank the engine. Releaseengine while warming it up. Drive at 5.To stop the engine, move the selector leverthe accelerator pedal when the enginemoderate speed for a short distance first, to the P (Park) position (CVTmodel) or movestarts. especially in cold weather. In cold weather, the shift lever to the N (Neutral) position (MT.Ifthe engine is very hard to startkeeptheenginerunningforaminimumof2- model), and turn the ignition switch to thebecause it is flooded, depress the3minutes before shutting it off. Starting and OFF position. accelerator pedal all the way to the floorstopping the engine over a short period of MODELSWITHINTELLIGENT KEY and hold it. Push the ignition switch totime may make the vehicle more difficult to the ON position to start cranking thestart. SYSTEM engine. After 5 or 6 seconds, stop cranking by pushing the ignition switchWhenracing the engine up to 4,000 rpm or 1.Apply the parking brake. to OFF. After cranking the engine,more under no load condition, the engine 2.Move the selector lever to the P (Park) or Nrelease the accelerator pedal. Crankwill enter the fuel cut mode. (Neutral) position. (P is recommended.)the engine with your foot off the5.To stop the engine, move the selector lever Thestarter is designed not to operate unlessaccelerator pedal by depressing theto the P (Park) position, and push the the selector lever is in either of the abovebrake pedal and pushing the push-ignition switch to the OFF position. positions. button ignition switch to start the engine. Ifthe engine starts, but fails to run, The Intelligent Key must be carriedrepeat the above procedure. when operating the ignition switch. 3.Push the ignition switch to the ON position.CAUTION Depress the brake pedal and push theDo not operate the starter for more ignition switch to start the engine.than 15 seconds at a time. If the engine To start the engine immediately, push anddoes not start, push the ignition switch release the ignition switch while depressingto OFF and wait 10 seconds before the brake pedal with the ignition switch incranking again, otherwise the starter any position. could be damaged. . Ifthe engine is very hard to start in Starting and driving5-13 Model "Z12-D" EDITED: 2009/ 9/ 17

owners manual Nissan Cube

owners manual Nissan Cube - year of production: 2008 - Nissan Cube owners manual EN