owners manual Subaru Outback

all ratings: 0 average rating: 5

Instruments and controls/Mirrors 3-65 6. Whenthe indicator light flashes slowly begins to flash slowly (after approximately and then rapidly after several seconds, 20seconds), position the hand-held trans- release both buttons. mitter of the device between 1 to 3 inches 7. Plug the motor of the entrance gate/ (25 to 76 mm) away from the HomeLink® garage door opener to the outlet. button you wish to program. 8. Test your entrance gate/garage door 3. Press and hold the hand-held trans- mitter button. The HomeLink® indicator opener by pressing the programmed HomeLink® button. light will flash, first slowly and then rapidly. 4. Whentheindicatorlight begins to flash ! Operating the HomeLink® Wire- rapidly, release both buttons. less Control System The programming for the previous device ® Wire- Once programmed, the HomeLink is now erased and the new device can be less Control System can be used to ® operated by pressing the HomeLink 1) HomeLink® button 1 remote-control the devices to which its button. ® button 2 2) HomeLink buttons are programmed. To activate a 3) HomeLink® button 3 device, simply press the appropriate but- !Erasing HomeLink® button mem- ton. The indicator light illuminates, indicat- ory 1. Press and hold the two outer buttons ing that the signal is being transmitted. (button 1 and button 3) until the indicator NOTE light begins to flash (after approximately !Programming other devices . Performing this procedure erases 20 seconds). To program other devices such as door the memory of all the preprogrammed 2. Release both buttons. locks, home lighting and security systems, buttons simultaneously. The memory ® at www.homelink.com contact HomeLink of individual buttons cannot be erased. !Incaseaproblem occurs or call 1-800-355-3515. . It is recommended that upon the If you cannot activate a device using the ! Reprogramming a single sale of the vehicle, the memory of all corresponding HomeLink® button after ® buttons be HomeLink® button programmed HomeLink programming, contact HomeLink® at erased for security purposes. www.homelink.com or call 1-800-355- 1. Press and hold the HomeLink® button 3515 for assistance. you wish to reprogram. DO NOT release the button until step 4 has been com- pleted. 2. When the HomeLink® indicator light – CONTINUED –

All pages in one PDF file!

How to get the code?
It's very simple! Just pay through a secure PayPal payment.
It will take no longer than a few minutes.
You will receive the code immediately after payment.
The code will be displayed on the screen and will be sent to you by e-mail address.

---

:

How many PDF files you want to download:
1 PDF file $4,00 USD 3 PDF files $8,00 USD 5 PDF files $12,00 USD

- I agree to the terms of service

Site map |
Privacy |
DMCA |
Terms of service
contact e-mail: contact @ man4car.com
All marks are the property of their respective holders