owners manual Subaru Outback

all ratings: 0 average rating: 5

Instruments and controls/Mirrors 3-63 NOTE ! Programming rolling-code-pro- Some gate operators and garage door tected garage door openers in openers may require you to replace the U.S.A. this programming step 4 with proce- If your garage door opener has a rolling dures in “Programming for entrance ® code feature, program the HomeLink gates and garage door openers in Wireless Control System for it by following Canada” F3-64. steps 1 through 5 in “Garage door opener 5. Hold down both buttons until the programming in the U.S.A.” F3-62. Then HomeLink® indicator light flashes, first continue with the following steps. slowly then rapidly. When the indicator NOTE light flashes rapidly, both buttons may be released. (The rapidly flashing light indi- The assistance of a second person cates successful programming of the new may make the programming quicker 1) HomeLink® button 1 frequency signal.) and easier. ® button 2 2) HomeLink 3) HomeLink® button 3 6. Press and hold the programmed but- ton and check the HomeLink® indicator 2. Press and hold the two outer light. If the indicator light stays on con- HomeLink® buttons (button 1 and button tinuously, your garage door should acti- 3) until the indicator light begins to flash vate and the programming is completed. (after approximately 10 seconds). Then release both buttons. If the indicator light flashes rapidly for 2 3. Hold the end of the garage door seconds and then stays on continuously, opener’s hand-held transmitter between your garage door opener may be pro- 1and3inches(25and76mm)awayfrom tected by a rolling code feature. In this the HomeLink® button you wish to pro- case you need to perform the additional gram. steps that are described in “Programming 4. Simultaneously press and hold both rolling-code-protected garage door open- the hand-held transmitter button and the ers in the U.S.A.” F3-63. 1. Locate the training button on the desired HomeLink® button. DO NOT re- garage door opener motor head unit. lease the buttons until step 5 has been The exact location and color of the button completed. mayvarybybrandofgaragedooropener. If it is difficult to locate the training button, – CONTINUED –

All pages in one PDF file!

How to get the code?
It's very simple! Just pay through a secure PayPal payment.
It will take no longer than a few minutes.
You will receive the code immediately after payment.
The code will be displayed on the screen and will be sent to you by e-mail address.

---

:

How many PDF files you want to download:
1 PDF file $4,00 USD 3 PDF files $8,00 USD 5 PDF files $12,00 USD

- I agree to the terms of service

Site map |
Privacy |
DMCA |
Terms of service
contact e-mail: contact @ man4car.com
All marks are the property of their respective holders